3.Identify the Right Upright (81) and the Right Upright Spacer (89), which are marked with “Right” stickers. Insert the Upright Wire (79) through the Right Upright Spacer as shown. Set the Right Upright Spacer on the Base (86).
Make sure the Upright Wire is not pinched. Have a second person hold the Right Upright (81) near the Base (86). See the inset drawing. Tie the long tie in the Right Upright securely around the end of the Upright Wire (79). Then, pull the other end of the long tie until the Upright Wire is routed completely through the Right Upright.
4.Hold a Bolt Spacer (80) inside the lower end of the Right Upright (81). Insert a 3/8" x 4" Bolt (6) with a 3/8" Star Washer (9) into the Right Upright and the Bolt Spacer. Repeat this step with a second Bolt Spacer (80), 3/8" x 4" Bolt (6), and 3/8" Star Washer (9).
Set the Right Upright (81) into the Right Upright Spacer (89). Make sure the Upright Wire (79) is not pinched.
Partially tighten the 3/8" x 4" Bolts (6); do not fully tighten the Bolts yet.
3 |
|
|
|
|
79 |
|
|
| 81 |
|
| 89 | 79 | |
Long |
|
| ||
|
| 86 | ||
Tie |
|
|
| |
| 81 |
|
|
|
79 | Long |
|
|
|
Tie |
|
|
| |
4 |
|
|
| 6 |
|
|
|
| |
| 81 | 89 |
| 9 |
|
|
| ||
|
|
|
| 79 |
|
|
|
| 80 |
8