TROUBLESHOOTING |
|
|
Most treadmill problems can be solved by following the steps below. Find the symptom that applies, and | ||
follow the steps listed. If further assistance is needed, please see the front cover of this manual. | ||
PROBLEM: The power does not turn on |
|
|
SOLUTION: a. Make sure that the power cord is plugged into a surge suppressor, and that the surge suppressor | ||
is plugged into a properly grounded outlet (see page 13). Use only a | ||
sor that meets all of the specifications described on page 13. IMPORTANT: The treadmill is not | ||
compatible with |
|
|
b. After the power cord has been plugged in, make sure that the key is inserted into the console. | ||
c. Check the reset/off circuit breaker located on the | c |
|
treadmill frame near the power cord. If the switch |
| |
protrudes as shown, the circuit breaker has | Tripped | Reset |
tripped. To reset the circuit breaker, wait for five | ||
minutes and then press the switch back in. | Position | Position |
PROBLEM: The power turns off during use |
|
|
SOLUTION: a. Check the reset/off circuit breaker (see the drawing above). If the circuit breaker has tripped, wait | ||
for five minutes and then press the switch back in. |
|
|
b. Make sure that the power cord is plugged in. If the power cord is plugged in, unplug it, wait for | ||
five minutes, and then plug it back in. |
|
|
c. Remove the key from the console. Reinsert the key into the console. |
| |
d. If the treadmill still will not run, please see the front cover of this manual. |
| |
PROBLEM: The console displays remain lit when you remove the key from the console |
| |
SOLUTION: a. The console features a display demo mode, designed to be used if the treadmill is displayed in a | ||
store. If the displays remain lit when you remove the key, the demo mode is turned on. To turn off | ||
the demo mode, hold down the Stop button for a few seconds. If the displays are still lit, see THE | ||
INFORMATION MODE on page 19 to turn off the demo mode. |
| |
PROBLEM: The displays of the console do not function properly |
|
|
SOLUTION: a. Adjust the incline level of the treadmill to 5 percent. | a | 85 |
Remove the key from the console and UNPLUG | ||
THE POWER CORD. With the help of a second |
|
|
person, carefully tip down the Uprights (85, 89). |
|
|
There may be two Screws (A) in the bottom of the |
|
|
Belly Pan (84). If there are, remove them. Note: A |
| 84 |
Phillips screwdriver with a shaft at least 5 in. (13 | 89 | |
cm) long is required. Then, raise the Uprights. | A | |
|
| A |
22