Remove the three M4.2 x 19mm Hood Screws (12) and carefully pivot the Hood (67) off.
12 |
67 |
Locate the Reed Switch (70) and the Magnet (51) |
|
|
|
on the left side of the Pulley (53). Turn the Pulley |
|
|
|
until the Magnet is aligned with the Reed Switch. | 1/8 in. |
| |
Make sure that the gap between the Magnet and | 51 | ||
the Reed Switch is about 1/8 in. (3 mm). If neces- |
| 70 | |
sary, loosen the M4.2 x 19mm Screw (1), move the |
| 53 | |
Reed Switch slightly, and then retighten the Screw. | Top |
| |
Reattach the Motor Hood (not shown) with the three |
|
| |
M4.2 x 19mm Hood Screws (not shown) and with | View |
|
|
the two Screws (not shown) if necessary. Run the |
|
|
|
treadmill for a few minutes to check for a correct |
|
|
|
speed reading. |
|
|
|
PROBLEM: The incline of the treadmill does not change correctly
SOLUTION: a. With the key in the console, press one of the Incline buttons. While the incline is changing, re- move the key. After a few seconds,
PROBLEM: The walking belt slows when walked on
SOLUTION: a. Use only a
b. If the walking belt is overtightened, treadmill perfor- | b |
|
mance may decrease and the walking belt may be- | ||
come damaged. Remove the key and UNPLUG |
| |
THE POWER CORD. Using the hex key, turn both |
|
|
idler roller bolts counterclockwise, 1/4 of a turn. |
|
|
When the walking belt is properly tightened, you |
|
|
should be able to lift each edge of the walking belt |
|
|
2 to 3 in. (5 to 7 cm) off the walking platform. Be |
|
|
careful to keep the walking belt centered. Then, |
|
|
plug in the power cord, insert the key, and run the | Idler Roller Bolts | |
treadmill for a few minutes. Repeat until the walking | ||
belt is properly tightened. |
|
|
c. If the walking belt still slows when walked on, see the front cover of this manual.
23