ProForm PFTL66906.0 user manual Shown. Do not overtighten the Wheel Bolt

2. Attach a Wheel (66) to the base of the Uprights	2				64
(69) with a Wheel Bolt (64) and a Nut (13) as
shown. Do not overtighten the Wheel Bolt; the				69	66
Wheel should turn freely.
					13
3. With the help of a second person, carefully tip	3
the treadmill onto its right side as shown.
Partially fold the Frame (86) so the treadmill is
more stable. Do not fully fold the treadmill
until it is completely assembled.
Insert an Extension Leg (63) into the base of the	66	64
					86
Uprights (69). Hold an Extension Leg Nut (46) in			69
the bottom of the Extension Leg, and thread a
Extension Leg Bolt (93) with a Star Washer (95)	13
into the top of the Extension Leg. Next, thread a
3” Bolt (96) with a Star Washer into the bottom of					93
the Extension leg. Firmly tighten the Bolts.	39	57
					95
	57	39
Attach two Base Pads (57) to the base of the
Uprights (69) with two 1” Tek Screws (39).			95	46
		96
Attach the other Wheel (66) to the base of the				63
Uprights (69) with a Wheel Bolt (64) and a Nut
(13). Do not overtighten the Wheel Bolt; the
Wheel should turn freely.
4. If there is a board (not shown) between the	4
Uprights (69), remove the two bolts attaching the
board. Discard the board and the bolts.	93
Remove the tie from the Wire Harness (42). Hold		71
one of the Handrails (71) near the right Upright
	95			42
(69), and insert the Wire Harness into the open-
		69
ing in the bottom of the Handrail and out of the			93
indicated hole in the top.
Set the Handrail (71) on the right Upright (69),			95
and tighten two Handrail Bolts (93) with two		71
Handrail Star Washers (95) into the Handrail and
the right Upright. Make sure that the Wire
Harness (42) is not pinched.				69
Attach the other Handrail (71) to the left Upright
(69) as described above. Note: There is not a
wire harness on the left side.
	7