ProForm PFTL79008.0 manual Uprights 77, 92. Be careful not to pinch any, Wires, Same way

12. Set the console assembly on the Left and Right	12
Uprights (77, 92). Be careful not to pinch any			Console Assembly
wires.
Attach the console assembly to the Pulse Bar
(110) with six #8 x 3/4" Screws (1). Start all six
Screws before firmly tightening any of them.
Note: Use the two Screws you removed in step 9.
		921	110	1	1	77
13. Identify the Right Handrail Cover (55), which is	13	Console
marked with a sticker. Slide the Right Handrail
Cover onto the right Handrail (80).		Assembly
Remove the paper backing from the tape in the		Tape
indicated location and press the Right Handrail		78
Cover (55) against the console assembly.	80
Tighten a #8 x 1/2" Screw (2) into the Right
Handrail Cover and the Right Upright (92); be		2
careful not to overtighten the Screw.
Attach the Left Handrail Cover (78) in the				Tape
same way.
				80	55	292
14. Carefully lower the Uprights (77, 92) as shown.	14	Console Assembly				Start First
Start the two indicated #8 x 1 1/2" Screws (3)
into the Left and Right Uprights (77, 92) and the						3
console assembly. If necessary, pull back on the							77
console assembly slightly to align the holes in
the Uprights with those on the console assem-	Start
bly. Start the other two #8 x 1 1/2" Screws (3)
and then tighten all four Screws; do not	First
overtighten the Screws. Then, raise the		3
Uprights (77, 92).				92
See steps 4 and 6. Firmly tighten the four 3/8" x
4" Bolts (8).
	11