ProForm PFTL79008.0 Make sure that the power cord is unplugged, Do not fully fold the Frame yet

1. Make sure that the power cord is unplugged.	1					Hole
With the help of a second person, carefully tip				91		97
the treadmill onto its left side. Partially fold the							6
Frame (48) so that the treadmill is more stable;
do not fully fold the Frame yet.						96
Cut the shipping tie securing the Wire Harness
(91) to the Base (96). Locate the plastic tie in
the indicated hole in the Base, and use the tie to
pull the Wire Harness out of the hole.	48	98 97	6
Attach two Base Feet (97) to the Base (96) in the
locations shown with two #8 x 1" Tek Screws (6)
and two Base Foot Spacers (98).						976
Then, attach the other two Base Feet (97) with
two #8 x 1" Tek Screws (6).
		98		97
2. See the inset drawing. Cut the plastic tie near	2	Plastic Tie
the Wire Harness (91).
Attach a Wheel (99) to the Base (96) with a 3/8"
x 2" Bolt (9) and a 3/8" Nut (10). Do not over-
tighten the Nut; the Wheel must turn freely.		9
		10 99		96		Cut
						91
3. Identify the Right Upright (92) and the Right	3
Upright Spacer (100), which are marked with
stickers. Insert the Wire Harness (91) through						92
the Right Upright Spacer as shown. Then, set
the Right Upright Spacer on the Base (96).	91
Have a second person hold the Right Upright		Wire Tie				91
(92) near the Base (96). See the inset drawing.					100
Tie the wire tie in the Right Upright securely
around the end of the Wire Harness (91). Then,							96
pull the other end of the wire tie until the Wire
Harness is routed completely through the Right
Upright.		92
	91	Wire
		Tie
	7