Assembly

Make sure that the power cord is unplugged. Assembly requires two persons. Set the treadmill in a cleared area and remove all packing materials. Do not dispose of the packing materials until assembly is completed. Note: The underside of the treadmill walking belt is coated with high-performance lubricant. During shipping, a small amount of lubricant may be transferred to the top of the walking belt or the shipping carton. This is a normal con- dition and does not affect treadmill performance. If there is lubricant on top of the walking belt, simply wipe off the lubricant with a soft cloth and a mild, non-abrasive cleaner.

Assembly requires the included allen wrenches		and your own phillips screwdriver
and wire cutters	.

Use the drawings below to identify the assembly hardware. The number in parentheses below each drawing is the key number of the part, from the PART LIST on pages 26 and 27. The number after the parentheses shows the quantity needed for assembly. Note: If a part is not in the parts bag, check to see if it is preattached to one of the parts to be assembled. If a part is missing, call toll-free1-888-533-1333. To avoid damaging plastic parts, do not use power tools for assembly.

	Screw (95)–8		3/4” Tek Screw (52)–4
Nut (20)–4	Washer (71)–4
1” Screw (88)–4	Base Pad Screw (40)–4		1 3/4” Bolt (76)–2
Wheel Bolt (90)–2		3” Bolt (86)–2
1. With the help of a second person, raise the Uprights (97)		1
to the vertical position.		1
to the vertical position.
Insert a Handrail Extension (105) into the post on the left			81
Upright (97), and align the small holes in the sides of the			81
Upright (97), and align the small holes in the sides of the			88
Handrail Extension with the small holes in the sides of			88
the post. Make sure that the Handrail Extension is
oriented so the slot is on top. Tighten two 3/4” Tek			52
Screws (52) into the sides of the post; make sure that		95	52
Screws (52) into the sides of the post; make sure that		95
the Screws are not directly opposite each other.		Slot		52
		Slot		52
Next, identify a Left Bottom Handgrip (43), which has a		105
large hole for the latch assembly. Hold the Left Bottom		105
large hole for the latch assembly. Hold the Left Bottom				Hole
Handgrip against the Handrail Extension (105) and the				Hole
Handgrip against the Handrail Extension (105) and the
post, and tighten two 1” Screws (88) and one Screw (95)
down into the Left Bottom Handgrip as shown.		43	95	97
				97
Attach the Left Top Handgrip (81) with three Screws (95)
Attach the Left Top Handgrip (81) with three Screws (95)
inserted through the Left Bottom Handgrip (43).
Repeat this step on the right side of the treadmill.
	5