THE INFORMATION MODE/DEMO MODE
The console features an information mode that keeps track of the total number of hours that the treadmill has been operated and the total number of miles that the walking belt has moved. The information mode also al- lows you to select miles or kilometers as the unit of measurement and to turn on and turn off the demo mode.
To select the information mode, hold down the Stop button while inserting the key into the console. When the information mode is selected, the following informa- tion will be shown in the display:
The left side of the display |
|
|
will show the total number of |
|
|
miles (or kilometers) that the | Miles |
|
walking belt has moved and | Hours | |
the total number of hours |
|
|
that the treadmill has been
used. An “E” for English miles or an “M” for metric kilo- meters will appear in the right side of the display. Press the Quick Speed increase button to change the unit of measurement.
IMPORTANT: If a “d” appears in the right side of the display, the console is in the “demo” mode. This mode is intended to be used only when a treadmill is dis- played in a store. When the console is in the demo mode, the power cord can be plugged in, the key can be removed from the console, and the indicators in the display will automatically appear in a preset sequence, although the buttons on the console will not operate. If a “d” appears when the information mode is selected, press the Quick Speed decrease button so “d” dis- appears.
To exit the information mode, remove the key from the console.
THE OPTIONAL CHEST PULSE SENSOR
An optional chest pulse sensor offers
If you purchase the optional chest pulse sensor, follow the steps below to install the receiver in- cluded with the chest pulse sensor.
1.Unplug the power cord. Remove the indicated Screw (95) and the Access Door (96) from the left side of the Console Base (101).
|
| Wire | |
101 |
| Small | |
|
| Screws | |
96 |
|
| |
95 | A | Small | |
Cylinder | |||
|
|
2.Connect the wire on the receiver (A) to the indicated wire extending from the Console Base (101). Hold the receiver so the small cylinder is oriented as shown and is facing the Console Back. Attach the receiver to the plastic posts on the Access Door (96) with the two included small screws.
3.Make sure that no wires are pinched. Reattach the Access Door (96) with the Screw (95). Discard the other wires included with the receiver.
20