2.Attach a Wheel (66) to the base of the Uprights (69) with a Wheel Bolt (64) and a Wheel Nut (32) as shown. Do not overtighten the Bolt; the Wheel should turn freely.
With the help of a second person, carefully tip the tread- mill onto its other side. See assembly steps 1 and 2, and attach the other Extension Leg (63), Base Pads (57), and Wheel (66).
With the help of a second person, carefully lower the base of the Uprights (69) to the floor so the Uprights are in the vertical position.
3.Identify the Right Handrail (72), which has a large hole in the left side. Remove the wire tie holding the Upright Wire (42) inside the right Upright (69). Feed the Upright Wire into the hole in the bottom of the Right Handrail and out of the large hole in the side. Note: It may be helpful to use needlenose pliers to pull the Wire Harness out of the hole.
Set the Right Handrail (72) on the right Upright (69). Attach the Right Handrail with two Handrail Bolt (37) and two Handrail Star Washers (95). Be careful not to pinch the Upright Wire (42).
Attach the Left Handrail (71) as described above. Note: There is not an upright wire on the left side.
4.Hold the Console Base (47) near the Left Handrail (71). Attach the end of the ground wire on the Console Base to the indicated small hole in the Left Handrail with the Silver Ground Screw (75).
7
2 |
| 64 |
|
| |
| 69 | 66 |
|
| |
|
| 32 |
3 |
|
|
37 | 71 |
|
|
| |
95 |
| 95 |
|
| |
| 37 | Hole |
| 42 |
|
| 95 |
|
| 72 |
|
|
| 69 |
4 |
|
|
Ground
Wire
47
Small
Hole
75
71