Assembly

Assembly requires two persons. Set the treadmill in a cleared area and remove all packing materials; do not dispose of the packing materials until assembly is completed. Note: The underside of the treadmill walking belt is coated with high-performance lubricant. During shipping, a small amount of lubricant may be transferred to the top of the walking belt or the shipping carton. This is a normal condition and does not affect treadmill perfor- mance. If there is lubricant on top of the walking belt, simply wipe off the lubricant with a soft cloth and a mild, non-abrasive cleaner.

Assembly requires the included allen wrenches		and your own phillips screwdriver	,
rubber mallet	, and adjustable wrench	.

For help identifying the assembly hardware, see the drawings below. If a part is not in the parts bag, first check to see if it has been pre-assembled.If a part is missing, call toll-free 1-888-533-1333.

1/2” Screw (48)–2	Small Star	Handrail Star		Extension Leg
			Nut (13)–2	Nut (46)–4
	Washer (24)–4	Washer (95)–2

Silver Ground	3/4” Tek Screw	1” Tek Screw (39)–4	Extension Leg Bolt (93)–4
Screw (75)–1	(58)–2
3/4” Screw (2)–9	Wheel Bolt (64)–2		Handrail Bolt (37)–2

1.Make sure that the power cord is unplugged.

With the help of a second person, carefully tip the treadmill onto its left side as shown. Partially fold the Frame (86) so the treadmill is more stable. Do not fully fold the treadmill until it is completely assembled.

Insert an Extension Leg (63) into the base of the Uprights (69), with the Extension Leg Pad (61) oriented as shown. If necessary, use a rubber mallet to fully insert the Extension Leg. Next, hold two Extension Leg Nuts (46) in the bottom of the Extension Leg, and insert two Extension Leg Bolts (93) into the top of the Extension Leg. Firmly tighten the Extension Leg Bolts into the Extension Leg Nuts.

Attach two Base Pads (57) to the base of the Uprights (69) with two 1” Tek Screws (39).

1
	57
69
93
	39
	39
63	46
61
86

ProForm 831.29604.0 user manual Assembly, Make sure that the power cord is unplugged

ASSEMBLY

1.Make sure that the power cord is unplugged.