TROUBLE-SHOOTING
Most treadmill problems can be solved by following the simple steps below. Find the symptom that ap- plies, and follow the steps listed. If further assistance is needed, call our
1.SYMPTOM: THE POWER DOES NOT TURN ON
a.Make sure that the power cord is plugged into a surge protector, and that the surge protector is plugged into a properly grounded outlet. (See HOW TO PLUG IN THE POWER CORD on page 9.) Use only a
b.After the power cord has been plugged in, make sure that the key is fully inserted into the console. (See step 1 on page 12.)
c. Check the circuit breaker located on the treadmill near the power cord. If the switch protrudes as shown, the circuit breaker has tripped. To reset the circuit breaker, wait for five minutes and then press the switch back in.
d. Check the on/off switch located at the front of the treadmill near the power cord. The switch must be in the ÒonÓ position.
2. SYMPTOM: THE POWER TURNS OFF DURING USE
c |
| |
Tripped | Reset | |
d |
| |
ÒOnÓ |
| |
Position | OFF | |
ON | ||
|
a. Check the circuit breaker located on the treadmill frame near the power cord (see 1. c. above). If the circuit breaker has tripped, wait for five minutes and then press the switch back in.
b. Make sure that the power cord is plugged in.
c. Remove the key from the console. Reinsert the key fully into the console. (See step 1 on page 12.)
d. Check to make sure that the on/off switch is in the ÒonÓ position. (See 1. d. above.)
e. If the treadmill still will not run, please call our
3. SYMPTOM: THE REMOTE CONTROL DOESNÕT FUNCTION PROPERLY
a. If the remote control doesnÕt function properly, the batteries should be replaced. Slide the battery cover off the back of the remote control. Press two ÒAAAÓ batteries into the remote con- trol. Make sure that the batteries are turned as shown. Reattach the battery cover.
Battery |
Cover |
ÒAAAÓ |
Batteries |
4.SYMPTOM: THE WALKING BELT SLOWS WHEN WALKED ON
a.Use only a
b.If the walking belt still slows when walked on, please call our
25