ProForm 785 TL HOW to Connect a VCR, Selecting the Data Channel, Using the Text Display Function

USING THE CLOSED CAPTION DECODER (CCD)

USING THE MENU FUNCTION

To turn the CCD on or off, press the CCD ON button. When the CCD is on, the TV screen will appear as shown below.

1. With CCD broadcast

A B C . . . . . . . . . .

. . . . . . . . . . X Y Z

2. Without CCD broadcast
caption mode on, text off	No Caption

When the menu is used, pressing the MENU button will display a menu that allows selection of channel mem- ory, the clock, the on timer, the off timer, or picture level controls. When the MENU button is pressed, the display will be as shown below.

	CH MEMORY		ANALOG
	ANALOG		CLOCK/TIMER
	CLOCK/TIMER
TV Mode		Video Mode
HOW TO CONNECT A VCR

3. Push CCD buttons, CCD
	CCD On
Note: In the cases shown	Ch 1
above, the display is for	Text Off
CCD caption mode on, text
mode off.

Selecting the Data Channel

When the CCD function is on, the data channel is se- lected by pressing the CCDÐ1, 2 button. The CCD func- tion status will be displayed for four seconds.

Follow the steps below to connect your VCR (not in- cluded) to the treadmill. A CATV cable (75 ohm coaxial cable) is required.

1.Connect one end of the CATV cable to the video out- put jack on the VCR.

2.Plug in the power cord of the VCR. Refer to your VCR userÕs manual for proper grounding instructions.

3.Connect the CATV cable to the 75 ohm antenna ter- minal on the treadmill. (See assembly drawing 6 on page 8 for the location of the terminal.)

Using the Text Display Function

The text function can be toggled on or off by pressing the CCD TEXT button. When the text function is on but no text data is received, the TV screen will appear as shown in drawing 2 above. The data channel can be selected while in the text mode, just as when in the cap-

To operate the VCR with the TV, make sure that the on/off switch located on the front of the motor hood is in the ÒonÓ position, and that the power cord is properly plugged in (see page 9).

ÒOnÓ Position

OFF

ON

tion mode.

Note: The closed-caption text will cover the exercise information at the bottom of the TV screen. If desired, the position of the exercise information can be changed to the top of the TV screen. See HOW TO SELECT THE INFORMATION MODE on page 15; refer to the paragraph at the bottom of the page.

To turn on the TV, press the POWER button on the TV or the remote control. Make sure that the TV is on channel 3 or 4. Note: When the treadmill is not in use, you may want to leave the surge protector plugged in. Each time the power cord is unplugged, the TV must go through an automatic channel resetting routine when the power is turned on again.

IMPORTANT: For the console and television to oper- ate properly, the VCR must be turned on, a videocas- sette must be properly inserted, and the VCR must be playing. Refer to your VCR userÕs manual for op- erating instructions.

22