HOW TO ADJUST THE CUSHIONING SYSTEM
Remove the key from the console and unplug the power cord. The treadmill features a cushioning sys- tem that reduces the impact as you walk or run on the treadmill. To increase the firmness of the walking plat- form, step off the treadmill and slide the cushion ad- justers toward the front of the treadmill. To decrease the firmness, slide the cushion adjusters toward the back of the treadmill. Note: Make sure that both ad- justers are set at the same firmness level. The faster you run on the treadmill, or the more you weigh, the firmer the walking platform should be.
Cushion |
|
Adjustor |
|
| Increase |
Decrease | Cushion |
| Adjustor |
| Walking Platform |
THE OPTIONAL CHEST PULSE SENSOR
An optional chest pulse sensor offers
To purchase the optional chest pulse sensor, call the telephone number on the front cover of this manual.
If you purchase the optional chest pulse sensor, follow the steps below to install the receiver in- cluded with the chest pulse sensor.
1.Make sure that the power cord is unplugged. Remove the indicated #8 x 3/4" Screw (12) and the Access Door (87) from the Console Base (93).
2.Connect the wire on the receiver (A) to the indi- cated wire extending from the Console Base (93).
Hold the receiver so that the small cylinder is oriented as shown and is facing the Console Base. Attach the receiver to the plastic posts on the Access Door (87) with the two included small screws.
3.Make sure that no wires are pinched. Reattach the Access Door (87) with the #8 x 3/4" Screw (12). Discard the other wires included with the receiver.
Small |
|
|
Screws |
|
|
A | Wires | 93 |
| ||
Small |
|
|
Cylinder |
|
|
87 |
|
|
12 |
|
|
22