ProForm 765 user manual Troubleshooting, Problem The power turns off during use

Page 25

TROUBLESHOOTING

Most treadmill problems can be solved by following the steps below. Find the symptom that applies, and follow the steps listed. If further assistance is needed, please see the front cover of this manual.

PROBLEM: The power does not turn on

SOLUTION: a. Make sure that the power cord is plugged into a surge suppressor, and that the surge suppressor is plugged into a properly grounded outlet (see page 12). Use only a single-outlet surge suppres- sor that meets all of the specifications described on page 12. Important: The treadmill is not com- patible with GFCI-equipped outlets.

b. After the power cord has been plugged in, make sure that the key is inserted into the console.

c.Check the reset/off circuit breaker located on the treadmill frame near the power cord. If the switch protrudes as shown, the circuit breaker has tripped. To reset the circuit breaker, wait for five minutes and then press the switch back in.

c

Tripped Position

Reset

Position

PROBLEM: The power turns off during use

SOLUTION: a. Check the reset/off circuit breaker (see the drawing above). If the circuit breaker has tripped, wait for five minutes and then press the switch back in.

b.Make sure that the power cord is plugged in. If the power cord is plugged in, unplug it, wait for five minutes, and then plug it back in.

c.Remove the key from the console. Reinsert the key into the console.

d.If the treadmill still will not run, please see the front cover of this manual.

PROBLEM: The incline of the treadmill does not change correctly

SOLUTION: a. With the key in the console, press one of the Incline buttons. While the incline is changing, re- move the key. After a few seconds, re-insert the key. The treadmill will automatically rise to the maximum incline level and then return to the minimum level. This will recalibrate the incline system.

PROBLEM: The displays of the console do not function properly

SOLUTION: a. Remove the key from the console and UNPLUG

a

THE POWER CORD. With the help of a second

74

person, carefully tip the Uprights (74, 78) down.

 

There may be two #8 x 2" Screws (105) in the bot-

 

tom of the Belly Pan (73). If there are, remove them.

 

Note: A Phillips screwdriver with a shaft at least 5

 

in. (13 cm) long is required. Then, raise the

73

Uprights.

78

 

 

105

 

105

25

Page 24 Page 26
Image 25
Page 24 Page 26
Contents Model No. PFTL79507.0 Serial No QUESTIONS?Call TOLL-FREE Table of Contents Important Precautions Page Before YOU Begin Hardware may be included AssemblyDo not fully fold the Frame yet Make sure that the power cord is unpluggedTighten the Nut the Wheel must turn freely See the inset drawing. Tie the long tieNot fully tighten the Bolts yet Be careful not to pinch the Upright WireFirmly tighten the Bolts Screws before tightening any of them Pull on the sleeve to make sure that it is locked into place HOW to Plug in the Power Cord Operation and AdjustmentPRE-LUBRICATED Walking Belt Features of the Console Console DiagramHOW to USE the Manual Mode HOW to Turn on the PowerSelect the manual mode Insert the key into the consoleChange the incline of the treadmill as desired Turn on the fan if desired Measure your heart rate if desiredSelect a cross training workout HOW to USE a Cross Training WorkoutPress the Quick Start button to start the work- out Continue the cross trainer workout Select a classic aerobic workout HOW to USE a Classic Aerobic WorkoutGet a monthly challenge goal Select the monthly challengeStart the workout Complete the workout. See steps 4-9 onInformation Mode HOW to Review Your Monthly Challenge LOGOptional Chest Pulse Sensor HOW to Adjust the Cushioning SystemHOW to Fold the Treadmill for Storage HOW to Fold and Move the TreadmillHOW to Move the Treadmill HOW to Lower the Treadmill for USE Problem The power turns off during use TroubleshootingProblem The walking belt slows when walked on Page Exercise Intensity Exercise GuidelinesWorkout Guidelines Exercise FrequencySuggested Stretches Key No. Qty Description R1207AQty Exploded Drawing A-Model No. PFTL79507.0 R1207A Exploded Drawing B-Model No. PFTL79507.0 R1207A Exploded Drawing C-Model No. PFTL79507.0 R1207A Exploded Drawing D-Model No. PFTL79507.0 R1207A Limited Warranty Ordering Replacement PartsIcon Health & FITNESS, INC., 1500 S W., LOGAN, UT
Top Page Image Contents