TROUBLESHOOTING
Most treadmill problems can be solved by following the steps below. Find the symptom that applies, and follow the steps listed. If further assistance is needed, please call our Customer Service Department toll-
free at
PROBLEM: The power does not turn on
SOLUTION: a. Make sure that the power cord is plugged into a surge suppressor, and that the surge suppressor is plugged into a properly grounded outlet (see page 8). Use only a
b. After the power cord has been plugged in, make sure that the key is fully inserted into the console.
c. Check the on/off circuit breaker located on the tread- mill near the power cord. If the switch protrudes as shown, the on/off circuit breaker has tripped. To reset the on/off circuit breaker, wait for five minutes and then press the switch back in.
c
Tripped
Reset
PROBLEM: The power turns off during use
SOLUTION: a. Check the on/off circuit breaker located on the treadmill frame near the power cord (see c.
above). If the on/off circuit breaker has tripped, wait for five minutes and then press the switch back in.
b. Make sure that the power cord is plugged in. If the power cord is plugged in, unplug it, wait for five minutes, and then plug it back in.
c. Remove the key from the console. Reinsert the key fully into the console.
d. If the treadmill still will not run, please call our
PROBLEM: The speed display on the console does not function properly
SOLUTION: | a. Remove the key and | UNPLUG THE POWER CORD | . | a | 64 | 37 |
| Carefully lower the Uprights (64) to the floor. Remove |
| ||||
|
|
| ||||
|
|
|
|
| ||
| the three indicated Small Screws (37). |
|
|
|
| |
| Raise the Uprights (64) to the vertical position. Pivot |
|
|
| 64 | |
| the Hood (1) off. |
|
|
|
| |
|
|
|
|
|
| 1 |
23