HOW TO USE PROGRAMS DIRECTLY FROM OUR WEB SITE
Our Web site at www.iFIT.com allows you to access programs directly from the internet. See www.iFIT.com for details. Note: Programs will control only the speed of your treadmill.
To use programs from our Web site, the treadmill must be connected to your home computer. See HOW TO CONNECT YOUR COMPUTER on page 16. In addition, you must have an internet connection and an internet service provider. A list of specific system re- quirements is found on our Web site.
Follow the steps below to use a program from our Web site.
1 Insert the key into the console.
See HOW TO TURN ON THE POWER on page 12.
2 Select the iFIT.com mode.
When the key is in-
serted, the manual
mode will be selected. To use a program from
our Web site, press the iFIT Speed button. The
indicator beside the button will light.
Go to your computer and start an internet
3 connection.
Start your web browser, if necessary, and go to
4 our Web site at www.iFIT.com.
Follow the desired links on our Web site to se-
5 lect a program.
Read and follow the
Follow the on-line instructions to start the
6 program.
When you start the program, an
Return to the treadmill and stand on the foot
7 rails. Find the clip attached to the key and slide the clip onto the waistband of your clothes.
When the
will begin and the walking belt will begin to move. Hold the handrails, step onto the walking belt, and begin walking. During the program, an electronic “chirping” sound will alert you when the speed of the treadmill is about to change. CAUTION:
Always listen for the “chirp” and be prepared for speed changes.
If the speed setting is too high or too low, you can manually override the setting at any time by press- ing the Speed buttons on the console. However, when the next “chirp” is heard, the speed will change to the next setting for the program.
To stop the walking belt at any time, press the Stop button on the console. The Time display will begin to flash. To restart the program, press the Start button or the Speed + button. After a mo- ment, the walking belt will begin to move. When the next “chirp” is heard, the speed will change to the next setting for the program.
When the program is completed, the walking belt will stop and the Time display will begin to flash. Note: To use another program, press the Stop button and go to step 5.
Note: If the speed of the treadmill does not change when a “chirp” is heard, make sure that the iFIT.com indicator is lit and that the Time display is not flashing. In addition, make sure that the audio cable is properly connected, that it is fully plugged in, and that it is not wrapped around a power cord.
8 Follow your progress with the displays.
See step 5 on page 12.
9 Measure your heart rate, if desired.
See step 6 on page 13.
10 Turn on the fan if desired.
See step 7 on page 13.
11 Whenkey. the program is completed, remove the
See step 7 on page 14.
19