ProForm PFT39110.0 user manual HOW to Fold and Move the Treadmill, HOW to Fold the Treadmill

Page 19

HOW TO FOLD AND MOVE THE TREADMILL

HOW TO FOLD THE TREADMILL

To avoid damaging the treadmill, adjust the incline to the lowest position before you fold the treadmill. Then, remove the key and unplug the power cord.

CAUTION: You must be able to safely lift 45 lbs. (20 kg) to raise, lower, or move the treadmill.

1. Hold the metal frame firmly in the location shown by the arrow below. CAUTION: Do not hold the frame by the plastic foot rails. Bend your legs and keep your back straight. Raise the frame about halfway to the vertical position.

1

Frame

2.Hold the treadmill firmly with your right hand as shown. Pull the latch knob to the left and hold it. Raise the frame until the hole in the platform cush- ion is aligned with the latch pin. Then, slowly re- lease the latch knob; make sure that the latch pin is fully inserted into the platform cushion.

2

Latch Engaged

Knob

Platform Cushion

To protect the floor or carpet, place a mat under the treadmill. Keep the treadmill out of direct sunlight. Do not leave the treadmill in the storage position in temperatures above 85° F (30° C).

HOW TO MOVE THE TREADMILL

Before moving the treadmill, fold it as described at the left. CAUTION: Make sure that the latch pin is fully inserted into the platform cushion. Moving the treadmill may require two people.

1.Hold the frame and one of the handrails, and place one foot against a wheel.

1

Frame Handrail

Wheel

2.Pull back on the handrail until the treadmill will roll on the wheels, and carefully move it to the desired location. CAUTION: Do not move the treadmill without tipping it back, do not pull on the frame, and do not move the treadmill over an uneven surface.

3.Place one foot against a wheel, and carefully lower the treadmill.

HOW TO LOWER THE TREADMILL FOR USE

1.See drawing 2. Hold the upper end of the treadmill with your right hand as shown. Pull the latch knob to the left and hold it. Next, lower the frame until it is past the latch pin. Then, release the latch knob.

2.See drawing 1 at the left. Hold the metal frame firmly with both hands, and lower it to the floor.

CAUTION: Do not hold the frame by the plastic foot rails, and do not drop the frame. Bend your legs and keep your back straight.

19

Image 19
Contents On the WEB QUESTIONS?Model No. PFTL39110.0 Serial No Mon.-Fri a.m.-6 p.m. MT Sat a.m.-4 p.m. MTTable of Contents Important Precautions Treadmill, and before performing the main Before YOU Begin Assembly Page See the left inset drawing. Identify the two See the far right drawing. Tie the wire tieMake sure that the end of the Upright Wire Does not fall into the Right UprightPage Bracket 70. Orient the Pulse Assembly so Careful not to pinch any wiresStart all four Bolts, and then firmly tighten Each of them If YOU do not Connect the CON Become Damaged When YOU Turn on PowerNectors PROPERLY, the Console MAY 2 Bolts Side View View from Above HOW to Plug in the Power Cord Operation and AdjustmentPRE-LUBRICATED Walking Belt Features of the Console Console DiagramStart the walking belt HOW to Turn on the PowerHOW to USE the Manual Mode Insert the key into the consoleMeasure your heart rate if desired. Before using HOW to USE a Preset Application Information Mode HOW to Lower the Treadmill for USE HOW to Fold and Move the TreadmillHOW to Fold the Treadmill HOW to Move the TreadmillProblem The power turns off during use TroubleshootingCompatible with GFCI-equipped outlets Walking belt has shifted to the right, turn the left View Problem The walking belt slows when walked onKey and Unplug the Power CORD. Using TopExercise Frequency Exercise GuidelinesExercise Intensity Workout GuidelinesKey No. Qty Description Part LIST-Model No. PFTL39110.0Exploded Drawing R0610A Exploded Drawing C-Model No. PFTL39110.0 Exploded Drawing D-Model No. PFTL39110.0 Limited Warranty Ordering Replacement PartsIcon Health & Fitness, Inc., 1500 S W., Logan, UT