ProForm PFT39110.0 user manual Treadmill, and before performing the main

Page 4

20. The pulse sensor is not a medical device.

25. DANGER: Always unplug the power

Various factors, including the user's move-

ment, may affect the accuracy of heart rate

cord immediately after use, before cleaning

the treadmill, and before performing the main-

readings. The pulse sensor is intended only

tenance and adjustment procedures de-

as an exercise aid in determining heart rate

scribed in this manual. Never remove the

trends in general.

motor hood unless instructed to do so by an

21. Do not attempt to raise, lower, or move the

authorized service representative. Servicing

treadmill until it is properly assembled. (See

other than the procedures in this manual

ASSEMBLY on page 6, and HOW TO FOLD

should be performed by an authorized service

AND MOVE THE TREADMILL on page 19.)

representative only.

You must be able to safely lift 45 lbs. (20 kg)

26. This treadmill is intended for in-home use

to raise, lower, or move the treadmill.

only. Do not use this treadmill in a commer-

22. When folding or moving the treadmill, make

cial, rental, or institutional setting.

sure that the storage latch is holding the

27. Over exercising may result in serious injury

frame securely in the storage position.

or death. If you feel faint or if you experience

23. Inspect and properly tighten all parts of the

pain while exercising, stop immediately and

treadmill regularly.

cool down.

24. Never insert any object into any opening on

the treadmill.

SAVE THESE INSTRUCTIONS

 

4

Page 3 Page 5
Image 4
Page 3 Page 5
Contents QUESTIONS? Model No. PFTL39110.0 Serial NoMon.-Fri a.m.-6 p.m. MT Sat a.m.-4 p.m. MT On the WEBTable of Contents Important Precautions Treadmill, and before performing the main Before YOU Begin Assembly Page See the far right drawing. Tie the wire tie Make sure that the end of the Upright WireDoes not fall into the Right Upright See the left inset drawing. Identify the twoPage Bracket 70. Orient the Pulse Assembly so Careful not to pinch any wiresStart all four Bolts, and then firmly tighten Each of them If YOU do not Connect the CON Become Damaged When YOU Turn on PowerNectors PROPERLY, the Console MAY 2 Bolts Side View View from Above HOW to Plug in the Power Cord Operation and AdjustmentPRE-LUBRICATED Walking Belt Console Diagram Features of the ConsoleHOW to Turn on the Power HOW to USE the Manual ModeInsert the key into the console Start the walking beltMeasure your heart rate if desired. Before using HOW to USE a Preset Application Information Mode HOW to Fold and Move the Treadmill HOW to Fold the TreadmillHOW to Move the Treadmill HOW to Lower the Treadmill for USEProblem The power turns off during use TroubleshootingCompatible with GFCI-equipped outlets View Problem The walking belt slows when walked on Key and Unplug the Power CORD. UsingTop Walking belt has shifted to the right, turn the leftExercise Guidelines Exercise IntensityWorkout Guidelines Exercise FrequencyPart LIST-Model No. PFTL39110.0 Key No. Qty DescriptionExploded Drawing R0610A Exploded Drawing C-Model No. PFTL39110.0 Exploded Drawing D-Model No. PFTL39110.0 Limited Warranty Ordering Replacement PartsIcon Health & Fitness, Inc., 1500 S W., Logan, UT
Top Page Image Contents