ProForm PFTL13011.0 user manual

Page 4

20.Never leave the treadmill unattended while it is running. Always remove the key, unplug the power cord, and press the power switch into the off position when the treadmill is not in use. (See the drawing on page 5 for the location of the power switch.)

21.Do not attempt to raise, lower, or move the treadmill until it is properly assembled. (See ASSEMBLY on page 7, and HOW TO FOLD AND MOVE THE TREADMILL on page 25.) You must be able to safely lift 45 lbs. (20 kg) to raise, lower, or move the treadmill.

22.When folding or moving the treadmill, make sure that the storage latch is holding the frame securely in the storage position.

23.Never insert any object into any opening on the treadmill.

24.Inspect and properly tighten all parts of the treadmill regularly.

25.DANGER: Always unplug the power cord immediately after use, before clean- ing the treadmill, and before performing the maintenance and adjustment procedures described in this manual. Never remove the motor hood unless instructed to do so by an authorized service representative. Servicing other than the procedures in this manual should be performed by an authorized ser- vice representative only.

26.This treadmill is intended for in-home use only. Do not use this treadmill in a commer- cial, rental, or institutional setting.

27.Over exercising may result in serious injury or death. If you feel faint or if you experience pain while exercising, stop immediately and cool down.

SAVE THESE INSTRUCTIONS

4

Image 4 Contents
QUESTIONS? Model No. PFTL13011.0 Serial NoCall TOLL-FREE Mon.-Fri a.m.-6 p.m. MT Sat a.m.-4 p.m. MTTable of Contents Important Precautions Page Before YOU Begin Part Identification Chart Assembly Make sure that the power cord is unpluggedSee the inset drawing. Tie the wire tie Be careful not to pinch the wires. If Fully tighten the Screws yet. Note It may beAttach the Right Upright not shown Base Covers into place yetScrews and Star Washers will be used Step Assembly. They will be used in step AssemblyStart all four Screws, and then tighten them Screws, and then tighten them Is shown. Start all four Screws, and then Tighten them Page HOW to PUT on the Heart Rate Monitor Care and MaintenanceTroubleshooting Chest Heart Rate MonitorHOW to Connect the Power Cord Operation and AdjustmentUse a Surge Suppressor Console Diagram Features of the Console HOW to Turn on the Power HOW to USE the Manual ModeSelect the manual mode Insert the key into the consoleChange the incline of the treadmill as desired Follow your progress with the displaysMeasure your heart rate if desired Turn on the fan if desiredSelect an onboard workout HOW to USE AN Onboard WorkoutStart the workout HOW to USE AN Ifit Live Workout Insert the iFit Live module into the consoleSelect an iFit Live workout Start the workout. See onCOOL-DOWN Mode HOW to USE the Stereo Sound SystemInformation Mode MetricHOW to Fold and Move the Treadmill HOW to Fold the TreadmillHOW to Move the Treadmill HOW to Lower the Treadmill for USESymptom The power does not turn on TroubleshootingSymptom The power turns off during use Symptom The walking belt slows when walked on Page Exercise Guidelines Exercise IntensityWorkout Guidelines Exercise FrequencyPart List Qty DescriptionDescription Qty Drawing a Exploded Drawing B Exploded Drawing C Exploded Drawing D Limited Warranty Ordering Replacement PartsIcon Health & Fitness, Inc., 1500 S W., Logan, UT
Related manuals
Manual 36 pages 30.55 Kb