ProForm 325i, PFTL31330 user manual Careful not to damage the Wire Harness, Open part bag C

2. Identify the Right Upright (108) and the Left Upright (73)			2
by observing the positions of the indicated brackets. See				42	Brackets
the inset drawing. Make sure that there are two U-Nuts
(118) in the lower end of each Upright.
Straighten the Wire Harness (42), and feed it into the			69	108
lower end of the Right Upright (108) and out of the upper
end.
Open part bag B.	Hold the Right Upright (108) against the		48		73
right side of the Base (69 ), with the bracket on the side			61
shown. Hand tighten	two 3” Bolts (61) with two 5/16” Star
Washers (48) into the Base and the Right Upright;		be
careful not to damage the Wire Harness (42).
With the help of a second person, carefully tip the tread-					73, 108
mill onto its other side. Attach the Left Upright (73) and
the other Wheel (not shown) as described above. Note:
There is not a wire harness on the left side.					118
3. With the help of a second person, raise the Right Upright			3
(108) and the Left Upright (not shown) to the vertical po-
sition.			Large
Identify the Right Handrail (72), which has a large hole in			Hole		63
					76
the left side. Feed the Wire Harness (42) up into the			42
					Bracket
bracket on the Right Handrail and out of the large hole in
the left side. Note: It may be helpful to use needlenose					76
pliers to pull the Wire Harness out of the large hole.
				63
Remove any plastic ties from the bracket.			72
Insert the bracket on the Right Handrail (72) into the top					108
			38
of the Right Upright (108). Attach the Right Handrail with
two 1” Bolts (63), two 1/4” Star Washers (76), two 2”			114
Bolts (114), and two 1/4” Washers (38) as shown.		Do
not tighten the Bolts yet.
4. Open part bag C.	Attach the Storage Latch (36) to the		4
Left Upright (73) with two 3/4” Screws (2). Make sure that
the large hole in the Storage Latch is on the side shown.
			30	36	73
Remove the Lock Knob (30) from the Lock Pin (35).
Make sure that the Lock Pin Collar (33) and the Spring
(32) are on the Lock Pin as shown. Insert the Lock Pin					32
into the Storage Latch (36), and tighten the Lock Knob			2
					35
back onto the Lock Pin.			Large Hole
Attach the Left Handrail (not shown) to the Left Upright					33

(73)as described in step 3. Note: There is not a wire har- ness on the left side.

7