ProForm PFTL31330, 325i user manual Touch, Side of the Right Handrail, Ends of the plastic ties

5.Set the Crossbar (40) on the brackets on the Handrails (71, 72). Attach the Crossbar with two Crossbar Screws (39)Do. not tighten the Crossbar Screws yet.

Attach the end of the ground wire to the small hole in the side of the Right Handrail (72) with a 1/2” Silver Screw (49).

6.Place the Console Base (47) on the Right Handrail (72) and the Left Handrail (not shown). Attach the Console Base with four 3/4” Screws (2) (only two Screws are shown). Do not overtighten the Screws.

Insert the Wire Harness (42) through the two indicated

plastic ties on the Console Base (47). Next,		touch the
Right Handrail (72) to discharge any static.		Refer to the
inset drawing. Find the 3-wire connector on the end of the
Wire Harness (42). Insert the connector into the red socket
beneath the console.	The connector should slide easily
into the socket and snap into place.		If the connector

does not slide easily and snap into place, turn the connec- tor and then insert it. Insert the 5-wire connector into the black socket beneath the console in the same way.

Make sure that the connectors and wires appear as

shown in the inset drawing. IF THE CONNECTORS ARE

NOT INSERTED PROPERLY, THE CONSOLE MAY BE

DAMAGED WHEN THE POWER IS TURNED ON.

7. Insert the excess Wire Harness (42) into the large hole in

the side of the Right Handrail (72).	Securely tighten the
plastic ties on the bottom of the Console Base (47) to
prevent the Wire Harness from slipping.	Then, cut off
the ends of the plastic ties.

Route the Wire Harness (42) through the indicated open- ing in the C onsole Base (47). Attach the Wire Cover (44) to the Console Base with a 1/2” Silver Screw (49).

Attach the Console Base (47) to the Crossbar (40) with two 3/4” Screws (2). Tighten the two Crossbar Screws (39).

5
71	Bracket
		Ground	49
		Wire
	39
		40
		39
		72
6	47
		42
	Ties	43
2
		72
		42
			3-wire	5-wire
7
	Ties	Opening	47
		42
			44
72
	39	40
		49	2

8