ASSEMBLY
Assembly requires two persons. Set the treadmill in a cleared area and remove all packing materials; do not dispose of the packing materials until assembly is completed. Note: The underside of the treadmill walking belt is coated with
Assembly requires the included hex key and your own phillips screwdriver | (with a | |
shaft at least 15 cm [6 in.] long) and wire cutters | . |
|
For help identifying the assembly hardware, see the drawings below. The number in parentheses below each drawing is the key number of the part, from the PART LIST on page 31. The number following the parentheses is the quantity needed for assembly. Note: If a part is not in the parts bag, check to see if it has been
Extension Leg Nut | Star Washer | 1” Tek Screw |
Screw | Console Bolt | Extension Leg Bolt |
1.Make sure that the power cord is unplugged.
With the help of a second person, carefully tip the treadmill onto its left side as shown. Partially fold the Frame (58) so the treadmill is more stable. Do not fully fold the frame until the treadmill is completely assem- bled.
Attach four Base Pads (82) (only two are shown) to the base of the Uprights (84) with four 1” Tek Screws (22).
Insert an Extension Leg (89) into the base of the Uprights (84) as shown. Hold two Extension Leg Nuts (67) in the bottom of the Extension Leg. Next, insert two Extension Leg Bolts (65) with Star Washers (8) into the top of the Extension Leg, and firmly tighten the Extension Leg Bolts into the Extension Leg Nuts.
With the help of a second person, carefully tip the treadmill onto its other side. Attach the other Extension Leg (not shown) as described above.
1 |
|
|
|
| 84 |
65 |
|
|
8 | 82 | 82 |
|
| |
89 |
|
|
|
| 22 |
|
| 67 |
58 |
|
|
6