ProForm Lwufp Try again. if the Connectors are not, That no wires are pinched, Screws yet

9.	Have a second person hold the console assem-	9
	bly near the Right Upright (76).		Console
	Connect the Upright Wire (63) to the console		Assembly
	wire. See the inset drawing. The connectors
	should slide together easily and snap into
	place. If they do not, turn one connector and
	try again. IF THE CONNECTORS ARE NOT
	CONNECTED PROPERLY, THE CONSOLE
	MAY BE DAMAGED WHEN THE POWER IS
	TURNED ON. Remove the long tie from the
	Upright Wire and the tie from the console wire.
	Then, insert the connectors into the Right Upright
	(76).
	Set the console assembly on the Right Upright			Console
	(76) and the Left Upright (not shown). Make sure		Console Wire
		63		Wire
	that no wires are pinched.
			Long
		76	Tie	63
10.	Start an M8 x 25mm Screw (5) and two 5/16"	10
	x 5/8" Screws (79) with two M8 Star Washers
	(6) into the Right Upright (76) and the Right
	Handrail (64) as shown. Do not tighten the
	Screws yet.
	Attach the Left Handrail (not shown) as de-
	scribed above. Then, firmly tighten all six
	Screws.
			64
			5	79
				6
			76
		11