ProForm Lwufp Assembly, Make sure that the power cord is unplugged, Age the Upright Wire

Page 7

ASSEMBLY

•To hire a service technician to assemble this prod- uct in your home, call 1-800-445-2480.

•Assembly requires two persons.

•Place all parts in a cleared area and remove the packing materials. Do not dispose of the packing materials until you finish all assembly steps.

•The underside of the walking belt is coated with high-performance lubricant. After shipping, there may be some lubricant on top of the walking belt or on the shipping carton. This is normal. If there is lubricant on top of the walking belt, wipe it off with a soft cloth and a mild, non-abrasive cleaner.

•To identify small parts, see page 6.

•Assembly requires the following tools:

the included hex keys

one Phillips screwdriver

scissors

•To avoid damaging parts, do not use power tools.

1. Make sure that the power cord is unplugged.

1

 

Remove and discard the two screws (A) and the

 

shipping bracket (B) from the right side of the

 

Base (74). Then, remove and discard the screws

 

and shipping bracket (not shown) from the left

B

side of the Base.

 

A

 

74

2. Locate the Upright Wire (63) bundled between

2

the Base (74) and the Belly Pan (52). Route the

Upright Wire into the Base and out of the indi-

 

cated hole.

 

Press a Base Cap (70) into each side of the

Base (74).

See the inset drawing. Cut the plastic tie near

 

 

the Upright Wire (63). Be careful not to dam-

52

74

age the Upright Wire.

 

 

 

70

Tie

63

Cut

Hole

 

 

63

 

 

7

Page 6 Page 8
Image 7
Page 6 Page 8
Contents Mon.-Fri a.m.-6 p.m. MT Sat a.m.-4 p.m. MT QUESTIONS?Model No. PFTL59010.0 Serial No CALL TOLL-FREETable of Contents Important Precautions Page Before YOU Begin Part Identification Chart Make sure that the power cord is unplugged AssemblyAge the Upright Wire Be careful not to pinch the Upright Wire See the inset drawing. Tie the wire tieTighten the Screws yet Page To overtighten the Screws Scribed above. Note There is not a wire on Left sideScribed above. Then, firmly tighten all six Screws Try again. if the Connectors are notThat no wires are pinched Screws yetPage HOW to Connect the Power Cord Operation AND ADJUSTMENTUse a Surge Suppressor Features of the Console Console DiagramHOW to USE the Manual Mode HOW to Turn on the PowerLower left dis- play-As you exercise Change the incline of the treadmill as desiredFollow your progress with the displays Measure your heart rate if desired Track-WhenSelect a calorie workout HOW to USE a Calorie WorkoutStart the workout Select a performance workout HOW to USE a Performance WorkoutSelect the duration of the workout if desired Insert an iFit card and select a workout HOW to USE AN Ifit WorkoutHOW to USE the Stereo Sound System Information ModeHOW to Lower the Treadmill for USE HOW to Fold and Move the TreadmillHOW to Fold the Treadmill HOW to Move the TreadmillSymptom The power does not turn on TroubleshootingSymptom The power turns off during use Symptom The walking belt slows when walked on Page Exercise Frequency Exercise GuidelinesExercise Intensity Workout GuidelinesSuggested Stretches Key No. Qty Description Part ListExploded Drawing a Exploded Drawing B Exploded Drawing C Exploded Drawing D Limited Warranty Ordering Replacement PartsIcon Health & Fitness, Inc., 1500 S W., Logan, UT
Top Page Image Contents