JVC FS-A52 manual Introduction, Precautions

Page 4

Introduction

We would like to thank you for purchasing one of our JVC products. Before operating this unit, read this manual carefully and thoroughly to obtain the best possible performance from your unit, and retain this manual for future reference.

About This Manual

This manual is organized as follows:

This manual mainly explains playback using the remote control, and the other operations such as recording operations using the buttons on the unit. You can use the buttons both on the remote control and on the unit for the same operations if they have the same or similar names (or marks), unless mentioned otherwise.

Basic and common information that is the same for many functions is grouped in one place, and is not repeated in each procedure. For instance, we do not repeat the information about turning on/off the unit, setting the volume, changing the sound effects, and others, which are explained in the section “Basic and Common Operations” on pages 10 – 13.

The following marks are used in this manual:

Gives you warning and caution to prevent from damage or risk of fire/electric shock. Furthermore, gives you information which is not good for obtaining the best possible performance from the unit.

Gives you information and hints you had better know.

Precautions

Installation

Install in a place which is level, dry and neither too hot nor too cold—between 5˚C (41˚F) and 35˚C (95˚F).

Install the unit in a location with adequate ventilation to prevent internal heat buildup in the unit.

Leave sufficient distance between the unit and the TV.

Keep the speakers away from the TV to avoid interference with TV.

DO NOT install the unit in a location near heat sources, or in a place subject to direct sunlight, excessive dust or vibration.

Power sources

When unplugging the unit from the wall outlet, always pull the plug, not the AC power cord.

DO NOT handle the AC power cord with wet hands.

Moisture condensation

Moisture may condense on the lens inside the unit in the following cases:

After starting heating in the room

In a damp room

If the unit is brought directly from a cold to a warm place Should this occur, the unit may malfunction. In this case, leave the unit turned on for a few hours until the moisture evaporates, unplug the AC power cord, then plug it in again.

Others

Should any metallic object or liquid fall into the unit, unplug the AC power cord and consult your dealer before operating any further.

If you are not going to operate the unit for an extended period of time, unplug the AC power cord from the wall outlet.

DO NOT disassemble the unit since there are no user serviceable parts inside.

If anything goes wrong, unplug the AC power cord and consult your dealer.

– 1 –

Image 4
Contents Compact Component System FS-A52- Consists of CA-FSA52 and SP-UXA52Mises en garde, précautions et indications diverses Class 1 Laser Product Produit Laser ClasseFor Canada/pour le Canada Precautions IntroductionContents Location of the Buttons Main UnitTop view Front viewDisplay-indicators Main unitRemote Control Remote controlGetting Started Putting the Batteries into the Remote ControlUnpacking FM antenna AM antennaTo connect an outdoor FM antenna To connect an outdoor AM antennaConnecting Speakers To connect speakersTo remove the speaker grilles To attach the speaker grille, put the projectionsConnecting Other Equipment To stop and cancel the display demonstration, pressTo connect analog audio equipment For playing the other equipment through this unitMain unit Top view Basic and Common OperationsMain unit Front view Turning On the Power Selecting the Sources and Starting PlayAdjusting the Volume Turning On/Off the Key-touch ToneReinforcing the Bass Sound Selecting the Sound ModesSetting the Display Illumination To adjust and register the colorTo select the color pattern To select TODAY’S ColorListening to FM and AM Broadcasts Presetting Stations Tuning in a StationTo change the FM reception mode Tuning in a Preset Station To check the clock time while listening to the broadcastCancel Playing Back a CDPrecautions on CD Playback Playing Back the Entire CD-Normal PlayBasic CD Operations Program Play To check the program contentsTo modify the program Repeating Tracks-Repeat Play Playing at Random-Random PlayTo skip the current track, press ¢ Playing Back a Tape DisplayPlaying Back a Tape To play both sides-Reverse ModeTo check the clock time while playing back a tape Using External Equipment Mode PROListening to External Equipment Recording from This Unit to External EquipmentPress AUX/MD Play the CD Player of this unitRecording on Tapes For recording operations, mainly use the buttons on the unitBefore You Start Recording To protect your recordingsTo keep the best recording and playback sound quality To demagnetize the headRecording FM/AM Broadcasts What’s a Recording Mode and Reverse Mode ?Recording CD-CD Synchronized Recording Recording External Equipment To record a single track during play or pauseUsing the Timers Using Recording Timer Setting the ClockHow Recording Timer actually works Using Daily Timer How Daily Timer actually worksPress SET When you have selected from FM or To turn off the Recording Timer after its setting is doneTimer-on time, then press SET Hour digit of timer-off time starts flashing onTimer-off time, then press SET Minute digit of timer-off time starts flashing onTimer Priority Using Sleep TimerHow Sleep Timer actually works Maintenance Cleaning the unitGeneral Notes Handling discsTroubleshooting Output Power 40 W 20 W + 20 W at 4 Ω 10 % THDAuthorized Service Centers Limited Warranty JVC 0102MWMMDWJEM