20.Wrap the Cable (45) around a 3 1/2Ó Pulley (35) in the direction shown. Attach the Pulley to the right Weight Upright (42) with an M10 x 93mm Bolt (43), an M10 Washer (6) and an M10 Nylon Locknut (1). Make sure the Bolt is mounted in the upper of the two holes, as shown.
21.Wrap one end of a Cable (45) around a 3 1/2Ó Pulley
(35)in the direction shown. Attach the Pulley to the Pulley Bracket (28) on the Right Base (25) with an M10 x 50mm Bolt (73) and an M10 Nylon Locknut (1).
Make sure the Cable moves smoothly over all Pulleys and that the Weight Carriage can slide freely on the Weight Upright.
Move to the other side of the unit and mount the remaining Cable (45) in the same manner as described in steps 20 to 23.
22.Slide one of the Barbell Racks (31) upwards and insert a Safety Stop (23) into the Barbell Upright (41), using the first hole from the bottom. Do the same for the other Barbell Rack.
Place the Barbell (74) in the
Secure the Barbell (74) by tightening two M8 x 41mm Bolts (34) into each Barbell Rack (31).
Attach two Weight Hooks (29) to the Barbell (74) with two M8 x 14mm Screws (30). This is best done by first inserting both Weight Hooks into the holes in the Barbell Racks (31) and Barbell Uprights (41). Then press the
Make sure the Weight Hooks (29) are positioned so they lock into both Barbell Racks (31) at the same time when you turn the Barbell (74).
20 |
|
|
| 6 | 1 |
| 40 |
|
| 43 |
|
| 35 |
|
| 45 | 42 |
|
| |
21 |
|
|
| 28 | 1 |
|
| |
25 | 73 |
|
| 35 | |
|
| |
| 45 |
|
22 |
|
|
| 41 |
|
| 31 | 29 |
74 |
|
|
| J | 34 |
|
| 30 |
| 23 |
|
13