1.Loosen the Lock Knob (68) on the right side of the Frame (1). Slide the Seat Frame (3) out until it stops. Tighten the Lock Knob.
Identify the Rear Stabilizer (76), which has no wheels. Attach the Rear Stabilizer to the Seat Frame
(3) with two M10 x 58mm Carriage Bolts (74) and two M10 Nylon Locknuts (72).
2.Identify the Front Stabilizer (75), which has wheels. Attach the Front Stabilizer to the Frame (1) with two M10 x 58mm Carriage Bolts (74) and two M10 Nylon Locknuts (72).
3.Attach the Upright (2) to the Frame (1) with three M10 x 25mm Button Head Screws (25) and three M10 Split Washers (26). Be careful not to pinch the Reed Switch Wire (13) or the Resistance Cable (10).
4.Route both Adapters (73) up through the Upright (2) as shown.
Attach the Handlebar (4) to the Upright (2) with two M6 x 25mm Hex Head Screws (14) and two M6 Split Washers (67), but do not tighten the Screws yet.
Make sure that the Screws are threaded into the indicated holes. Note: Two additional Screws will be attached in step 6.
1 | 68 |
|
|
| 3 |
1 |
|
|
|
| 72 |
| 72 |
|
| 76 |
|
|
| 74 |
2 |
|
|
72 |
|
|
1 |
|
|
Wheels |
|
|
|
| 75 |
|
| 74 |
3 |
|
|
2 |
|
|
|
| 25 |
26 |
| 26 |
|
| 25 |
25 | 10 | 13 |
| ||
|
| |
|
| 1 |
4 | 14 |
|
|
| |
67 | 67 |
|
73 |
| |
|
| |
14 |
| 4 |
2 |
|
|
5