5.Connect the Reed Switch Wire (13) and the two Adapters (73) to the corresponding wires on the Console (8).
If your Console (8) has a ground wire, attach it to the Upright (2) with an M4 x 16mm Screw (34).
Next, attach the Console (8) to the Upright (2) with four #8 x 5/8” Screws (22).
Press the Resistance Knob (9) onto the Resistance Control (10). Be sure that the mark on the Knob is correctly aligned.
6.Finish attaching the Handlebar (4) to the Upright (2) with two more M6 x 25mm Hex Head Screws (14) and two more M6 Split Washers (67). Tighten all four Hex Head Screws.
7.Attach the Seat Bracket (69) to the Seat Frame (3) with four M10 x 105mm Button Head Bolts (70), four M10 Flat Washers (71), and four M10 Nylon Locknuts (72).
8.Attach the Seat (16) to the Seat Bracket (69) with four M6 x 16mm Hex Head Screws (24).
5 |
| |
8 | 9 | |
Console |
| |
Wires |
| |
73 | Ground | |
Wire | ||
13 | ||
34 | ||
22 | 10 | |
| 2 | |
| 22 | |
6 |
| |
| 14 | |
| 67 | |
67 |
| |
14 | 4 | |
| 2 | |
7 | 70 | |
| 69 | |
| 3 | |
| 71 | |
| 71 | |
| 72 | |
8 | 16 | |
| ||
| 69 | |
| 24 |
6