ProForm PFCCEL87078 Description of the Console, Battery Installation, HOW to Operate the Console

Page 10
Mode Indicators

DESCRIPTION OF THE CONSOLE

The console is designed to help you get the most

from your workouts. As you exercise, you can watch your progress around the LED track, while the display provides continuous exercise feedback.

The six modes of the display are described below.

LED Track

SPEED—This mode displays your current exercise speed, in miles per hour.

TIME—This mode displays the length of time you

have exercised. Note: If you stop exercising, the time mode will pause until you resume.

DIST.—This mode displays the total distance you have completed, in miles.

LAPS—This mode displays the number of 1/4-mile laps you have completed around the LED track.

CAL.—This mode displays the approximate number of Calories you have burned.

SCAN—This mode displays the speed, time, distance, laps, and calorie modes, for 5 seconds each, in a repeating cycle.

BATTERY INSTALLATION

Before the console can be operated, two “AA” batteries must be installed. If you have not installed batteries, see assembly step 7 on page 8.

HOW TO OPERATE THE CONSOLE

If there is a thin sheet of clear plastic on the face of the console, remove it.

1.To turn on the power, press the “on/reset” button or simply begin exercising. When the power is turned on, one LED indicator will light in the LED track, and the entire display will appear for two seconds. The console will then be ready for operation.

2.Select one of the six modes:

Scan mode—

When the power is turned on, the scan mode will automatically be selected. One

mode indicator will show that the

scan mode is selected, and a flashing mode indica- tor will show which mode is currently displayed. Note: If a different mode is selected, you can select the scan mode again by repeatedly pressing the mode button.

Speed, Time,

Distance, Laps, or Calorie mode—To select one of these modes for continuous dis-

play, press the

mode button repeatedly. The mode indicators will show which mode is selected. (Make sure that the scan mode is not selected.)

3.The LED track represents a distance of 1/4 mile. As you exercise, the indicators around the track will light one at a time until you have completed 1/4 mile. A new lap will then begin.

4.To reset the display, press the “on/reset” button.

5.To turn off the power, simply wait for about four minutes. Note: The console has an “auto-off” feature. If the pedals are not moved and the console buttons are not pressed for four minutes, the power will turn off automatically in order to conserve the batteries.

10

Image 10
Contents QUESTIONS? Customer HOT LineTable of Contents It is the responsibility of the owner to Important PrecautionsUsing the Proform 485E Decal shown at the right has been placed onFront Before YOU BeginYou use the Proform Left SidePre-attached Part Identification ChartExtra parts may be included Remove AssemblyTwo people Two adjuApply Apply a thin film of the included grease to the axlesRidge GreaseBatteries Battery Clip Floor or carpet from damageHOW to Exercise on the Elliptical Exerciser HOW to Adjust the Resistance PedalsHOW to Operate the Console Battery InstallationDescription of the Console Console TROUBLE-SHOOTING MaintenanceElliptical exerciser can be wiped clean with a soft Mild detergentExercise Intensity HOW to Measure Your Heart RateConditioning Guidelines Workout GuidelinesExercise Frequency Suggested StretchesPart LIST-Model No. PFCCEL87078 Key Qty DescriptionR1299A Model No Serial No Customer RecordDate Page Page Ordering Replacement Parts Limited Warranty Product Warranty Registration