MAINTENANCE AND TROUBLESHOOTING
Inspect and tighten all parts of the crosstrainer regu- larly. Replace any worn parts immediately.
To clean the crosstrainer, use a damp cloth and a small amount of mild soap. Important: To avoid damage to the console, keep liquids away from the console and keep the console out of direct sunlight.
BATTERY REPLACEMENT
If the console display becomes dim, the batteries should be replaced; most console problems are the result of low batteries. See assembly step 10 on page 7 for replacement instructions. Note: The console requires four “D” batteries.
HOW TO LEVEL THE CROSSTRAINER
After the |
| |
crosstrainer has |
| |
been moved to |
| |
the location |
| |
where it will be |
| |
used, make sure |
| |
that both ends of |
| |
front stabilizer | Foot | |
are touching the | ||
| ||
floor. If the |
| |
crosstrainer |
|
rocks slightly during use, turn one or both of the feet under the front stabilizer until the rocking motion is eliminated.
HANDGRIP PULSE SENSOR TROUBLESHOOTING
•Avoid moving your hands while using the handgrip pulse sensor. Excessive movement may interfere with heart rate readings.
•Do not hold the metal contacts too tightly; doing so may interfere with heart rate readings.
•For the most accurate heart rate reading, hold the metal contacts for about 15 seconds.
•For optimal performance of the handgrip pulse sen- sor, keep the metal contacts clean. The contacts can be cleaned with a soft
HOW TO MOVE THE CROSSTRAINER
Before moving the crosstrainer, remove the hand weights and adjust the seat to the position shown in the drawing below. Then, stand behind the crosstrain- er, hold the rail in the indicated location, and lift the rail until the crosstrainer can be moved on the front wheels. Carefully move the crosstrainer to the desired location and then lower it. CAUTION: To decrease the possibility of injury, bend your legs and keep your back straight as you lift the rail and move the crosstrainer; make sure to lift with your legs rather than your back.
Wheel |
Lift |
Here |
21