Assembly

Assembly requires two persons. Place all parts of the recumbent cycle in a cleared area and remove the pack- ing materials. Do not dispose of the packing materials until assembly is completed.

Assembly requires the included tools and your own adjustable wrench .

Use the drawings below to identify the small parts used in assembly. The number in parenthesis below each drawing refers to the key number of the part, from the PART LIST on page 18. The second number refers to the quantity needed for assembly. Note: Some small parts may have been pre-attached for shipping. If a part is not in the parts bag, check to see if it has been pre-assembled.

M6 Nylon	M6 Split	M6 Flat	M10 Split
Locknut (71)–4	Washer (57)–4	Washer (67)–4	Washer (46)–7

M8 Flat Washer	M4 x 16mm	M6 x 12.7mm	M6 x 16mm
(80)–4	Screw (64)–2	Button Screw (62)–4	Button Screw (68)–8

M10 x 25mm Button		M6 x 35mm Button
Screw (81)–7		Bolt (70)–4
1. Attach the Rear Stabilizer (8) to the Frame (1) with	1
four M10 x 25mm Button Screws (81) and four M10	1
four M10 x 25mm Button Screws (81) and four M10
Split Washers (46).
	1	8
	1	46
		46
		46
		81