11.Apply a generous amount of grease to two Pedal Leg Axles (32). Insert one Pedal Leg Axle into the bottom of the Left Handlebar Leg (11). Insert the other Pedal Leg Axle into the left Roller Leg (21).
Apply a small amount of grease to both sides of two Wave Washers (98). Place a Wave Washer on each Pedal Leg Axle (32).
Orient the Left Pedal Leg (14) as shown, and slide it onto the Pedal Leg Axles (32). Attach the Left Pedal Leg to the Left Handlebar Leg (11) with two M10 x 23mm Shoulder Screws (80), two M10 x 20mm x 2mm Washers (92), and two Axle Caps (31).
Attach the Left Pedal Leg (14) to the left Roller Leg (21) with two M10 x 20mm Button Screws
(91)and two M10 x 25mm Washers (94); do not overtighten the Button Screws. The Legs (11, 14, 21) must be able to pivot freely.
Repeat this step for the Right Pedal Leg (not shown).
12.The Console (5) requires four 1.5V “D” batteries (not included); alkaline batteries are recommended. See the inset drawing. Remove the battery cover from the Console and insert four batteries into the Console. Make sure that the batteries are oriented as shown by the dia- gram in the battery compartment. Then, reattach the battery cover.
Have a second person hold the Console (5) near the Upright (6) as shown. Connect the console wire to the Wire Harness (48). Insert the excess wire downward into the Upright.
Attach the Console (5) to the Upright (6) with four M4 x 16mm
11 |
|
|
|
| |
| 11 |
|
|
| |
Grease | 32 |
| 21 |
| |
| 80 |
|
| ||
98 |
| 94 | 91 | ||
31 | 92 | ||||
|
| ||||
|
|
| |||
|
| Grease | 32 |
| |
|
| 98 |
|
| |
31 |
|
|
|
| |
92 |
|
|
|
| |
80 | 14 |
|
|
| |
94 |
|
| |||
|
|
| |||
| 91 |
|
|
| |
12 |
|
|
|
| |
|
| Battery Cover |
| ||
5 |
|
|
|
| |
|
| 5 |
|
| |
| 6 | 48 |
|
| |
79 |
|
|
|
| |
|
|
| Console |
| |
|
|
| Wire |
| |
13.Make sure that all parts of the elliptical exerciser are properly tightened. Note: Some hardware may be left over after assembly is completed. To protect the floor or carpet from damage, place a mat under the elliptical exerciser.
10