BATTERY INSTALLATION
The console requires four “D” batteries. To install bat- teries, refer to assembly step 5 on page 7.
HOW TO OPERATE THE CONSOLE
Note: If there is a piece of clear plastic on the face of the console, remove it before operating the console.
1. To turn on the power, press the On/Reset button or begin pedaling.
2.Begin exercising and monitor your progress with the two displays.
Left display— |
|
This display |
|
shows the |
|
elapsed time |
|
and the dis- |
|
tance that you | Indicators |
have pedaled. | |
The display will |
|
change from |
|
one number to the other every seven seconds, as shown by the indicators in the display.
Right display— This display shows your
pedaling speed and the approx- imate numbers of calories and
fat calories you have burned.
When the thumb pulse sensor is used, the display will also show your heart rate (see step 3 at the right). Every seven seconds, the display will change from one number to the next, as shown by the indi- cators in the display.
To reset the displays at any time, press the On/Reset button.
3. Measure your heart rate, if desired.
To measure your heart rate, stop pedaling and place your
thumb on the pulse sensor as shown. The
pulse sensor is pressure activat-
level. After a few seconds, two dashes will
appear in the display, and then your heart rate will be
shown. Hold your thumb on
the pulse sensor for another 15 seconds for the most accurate reading. If the displayed heart rate appears to be too high or too low, or if your heart rate is not displayed, lift your thumb off the pulse sensor and allow the display to reset. Press down again on the pulse sensor as described above.
Make sure that you are applying the proper amount of pressure to the pulse sensor. Try the pulse sensor several times until you become familiar with it. Remember to sit still while measuring your heart rate.
4.To turn off the power, simply wait for a few minutes.
The console has an
10