Citizen C650 manual Order in which Registered Cities and Displayed, All-Reset Procedure

Return to Table of Contents

6.Turn the crown to display the time difference.

7.After setting, return the crown to the normal position.

<Characters and Symbols Used in City Names>

•Letters of the alphabet (A to Z)

•Numbers (0-9)

•Symbols (--: hyphens, M: blank spaces)

<Display Sequence>

When the crown is turned forward (clockwise), the display changes in the order of letters (A-Z), numbers (0-9) and then symbols (M: blank spaces, --: hyphens).

When the crown is turned backward (counter-clockwise), the display sequence is opposite that when turning the crown forward.

<Order in which Registered Cities and Displayed>

The location having the same time difference among the 30 cities pre-registered in this watch is displayed first. However, a city is not displayed if the time difference of a registered city has not been set.

<Canceling Registered Cities>

1.Turn the crown to set the mode hand to the zone setting [SET) mode.

2.When the crown is pulled out to the second click (city setting position), the watch enters the city name correction state.

3.Turn the crown to change the display of the registered city name to 4. After canceling registration, return the crown to the normal position.

15. ALL-RESET

When this watch indicates an abnormal display or does not function properly (no display, alarm continues to sound, etc.) as a result of being subjected to the effects of static electricity or strong impact and so forth, perform the all-reset procedure described below.

When performing the all-reset procedure, first make sure that the watch is sufficiently charged and that the charge indicator is lit.

<All-Reset Procedure>

1.Turn the crown to set the mode hand to the chronograph [CHR] mode.

2.Pull out the crown to the second click (0- position correction mode).

The second hand, minute hand, hour hand, 24 hour hand, UTC hour hand and

UTC minute hand rapidly advances to the 0 position stored in memory.

3.Press buttons (A) and (B) simultaneously and then release. All segments of the digital display are shown when either of the buttons is released.

Return to Table of Contents