JVC GVT0004-003A, CA-D702T Setting the Clock, Turning the Power On and Off, Adjusting the Volume

Page 12

English

 

 

Setting the Clock

1

 

Before operating the unit, set the correct time.

 

 

You can set the clock whether the Unit is on or off.

 

 

1.

Press TIMER/CLOCK.

 

 

 

The hour digits begin flashing.

 

 

 

Flashing

2 ,

4

2.

Press 4 P. DOWN or ¢ P. UP on

 

 

 

the MULTI CONTROL to set the hours.

 

 

 

Press ¢P. UP to increase the hour. Press 4 P. DOWN

 

 

 

to decrease the hour. Holding down continuously changes

 

 

 

the hour setting more rapidly.

 

 

3.

Press SET.

 

 

 

The minute digits begin flashing.

 

 

4.

Flashing

3 ,

5

Press 4 P. DOWN or ¢ P. UP on

the MULTI CONTROL to set the minutes. Press ¢P. UP to increase the minutes. Press 4 P. DOWN to decrease the minutes. Holding down continuously changes the minute setting more rapidly.

5. Press SET.

“CLOCK OK” appears on the display.

The clock stops flashing, and the clock timer starts from 0 second.

If the clock is not set, “0:00” will flash instead of the clock indication.

When the time has been set, TIMER/CLOCK can be used to operate the Daily Timer and Recording Timer.

To adjust the time once the clock has been set, press TIMER/CLOCK 5 times and follow the proce- dure above.

CAUTION: If there is a power failure, the clock loses its setting.

The display shows “0:00”, and the clock must be reset.

Turning the Power On and Off

Turning the System On ——————————————————

Press .

“WELCOME” appears on the display and the STANDBY indicator goes out.

The System comes on ready to continue in the mode it was in when the power was last turned off.

or

 

If the last thing you were doing was listening to a tape in Deck B, you are now ready to listen to a

 

 

tape again in Deck B, or you can change to another source.

 

 

If you were listening to the Tuner last, the Tuner comes on playing the station it was last set to.

 

 

Turning the System Off ——————————————————

Press again. “GOOD BYE” appears on the display for a while and the STANDBY indicator lights up. The clock time appears on the display.

Some power (12 watts) is always consumed even though the power is on standby.

To switch off the Unit completely, unplug the AC power cord from the AC outlet. When you unplug the AC power cord, the clock will be reset to 0:00 immediately, and preset Tuner stations will be erased in a few days.

 

Adjusting the Volume

+

Turn VOLUME clockwise to increase the volume or anticlockwise to decrease it.

 

Turning VOLUME quickly also adjusts the volume level quickly.

or VOLUME

When using the Remote Control, press VOLUME + to increase the volume or press VOLUME – to

–

decrease it.

You can adjust the volume level between 0 and 50.

8

Page 11 Page 13
Image 12
Page 11 Page 13
Contents CA-D702T If in Doubt Consult a Competent Electrician Class Laser Product Precaución el aparato debe estar bien ventilado Precaução Ventilação adequadaFeatures Installation of the UnitPower cord How This Manual Is OrganizedTable of Contents Accessories Setting the Voltage Selector SwitchHow to Put Batteries in the Remote Control Using the Remote ControlConnecting the FM Antenna Connecting the AM AntennaUsing the Supplied Wire Antenna Using an FM 75-Ohm Antenna Cable not suppliedConnecting the Speakers Connecting the Optional SpeakersRight Speaker Connecting Auxiliary Equipment On the Remote ControlVCR or other equipment On the UnitDemo Mode Common OperationsDisplay Setting the Clock Turning the Power On and OffAdjusting the Volume Turning the System OnBalance Adjustment Reinforcing the Bass SoundFor private listening Press Shift Press Balance L 10 or R +10Customizing a Sound Mode Sound ModesWhen a Rear Speaker is Connected Adjusting the Rear Speaker LevelUse Multi Control to adjust to any Sound Mode desired FrontTurn down the volume level to Press AUX Listening to Auxiliary EquipmentAccessing the Dolby Surround Functions Dolby Surround3CH Logic Center Speaker Mode Delay Time ModeAdjusting the level of the Center Speaker Adjusting the level of the Rear Speakers for PRO Logic onlySetting-up Dolby Pro Logic Getting Ready to Use Dolby Pro LogicSpeaker Arrangements for Dolby Pro Logic Using Dolby Surround Setting-up Dolby 3ch LogicGetting Ready to Use Dolby 3 Channel Logic Speaker Arrangements for Dolby 3 Channel LogicUsing the Tuner Tuning in a StationSetting the AM Tuner Interval Spacing Presetting Stations Switching between Frequency BandsThree Ways to Select a Station Changing the FM Reception Mode Using the CD Player Entering CD Operation Mode with the Remote ControlDisc indicator CD indicatorBasics of Using the CD Player Continuous Play Loading CDsPlaying a CD Locating a Track with the Remote Control Directly Selecting a TrackFast Forward / Reverse Changing Discs While PlayingOn the Remote Control Press PROGRAM/RANDOM on the Unit Programing the Playing OrderTracks On the Unit Press PROGRAM/RANDOMRandom Play Checking the ProgramChanging the Program Press the number keys 1 to 10 and +10 to select the tracksRepeating a Track or the Discs Tray Lock FunctionLocking the Trays Unlocking the TraysUsing the Cassette Deck Entering the Tape Operation Mode with the Remote ControlTape ª £ Regular Play Music ScanFast Left and Fast Right Finding the Beginning of the Current SelectionReverse Mode Reverse Mode on Reverse Mode OFFRecording Things to Know before You Start RecordingStandard Recording Check the recording direction for the tapePress Tape Control then press To pause at any time during the recording processCD Direct Recording Auto Edit RecordingRecording AM Station to Tape How to Use Dubbing Tape to Tape Recording DubbingPress Dubbing To stop dubbing, press 7STOPUsing the Timer Setting the Daily Timer Press TIMER/CLOCK againSet the time you want the Unit to turn on Set the time you want the Unit to turn offTurning the Daily Timer On and Off Setting the Volume LevelTo change the Daily Timer setting To use a Cassette Deck as the sourceSetting the Recording Timer Setting the Sleep Timer Turning the Recording Timer On and OffTo change the Sleep Timer setting To cancel the Sleep Timer settingTimer Priority Example Setting OperationRecording Timer Sleep TimerUsing the Microphone Karaoke Sing AlongSound Display Singing Along with KaraokePress FM MODE/ECHO on the Remote Control Digital EchoRecording Your Singing Microphone Mixing Playing the Microphone Sound through the SpeakersRecording Microphone Mixing Recording from the MicrophoneCare and Maintenance Compact Discs Cassette TapesMoisture Condensation General NotesTroubleshooting SymptomPossible Cause ActionSpecifications Important for mains AC line
Top Page Image Contents