JVC GVT0004-003A, CA-D702T manual Setting the Recording Timer

Page 40

English

CAUTION: If the Unit is unplugged, or a power failure occurs, the timer setting will be erased in a few days. If the settings are erased in this way, reset the timer settings.

Setting the Recording Timer

With the Recording Timer you can make a tape of a radio broadcast automatically whether or not you are home. For the timer to work correctly, you need to make sure of the following in addition to setting the time for the Tuner and Cassette Deck to come on:

You can set the Recording Timer whether the Unit is on or off. The tape you want to record onto must be in Deck B.

Procedure for Setting the Recording Timer

1. Press TIMER/CLOCK repeatedly until “REC” appears on the display. The REC indicator flashes on the display.

• Each time you press the button, the timer setting indication changes as follows: DAILY =ON TIME (flashes) =REC =ON TIME (flashes) =Clock setting =Canceled (current source) =(back to the beginning)

Note: If the clock has not been set, even if TIMER/CLOCK is pressed you cannot select the Recording

Timer.

2. Press TIMER/CLOCK again.

After “ON TIME” flashes for 2 seconds, it switches to the time setting display.

3. Set the time you want the Unit to be turned on.

Press 4P. DOWN or ¢P. UP on the MULTI CONTROL to adjust the hours and press SET. Then press 4P. DOWN or ¢P. UP to adjust the minutes and press SET .

4. Set the time you want the Unit to be turned off.

Press 4P. DOWN or ¢P. UP on the MULTI CONTROL to adjust the hours and press SET. Then press 4P. DOWN or ¢P. UP to adjust the minutes and press SET.

5. Select the Recording band.

Press 4P. DOWN or ¢P. UP on the MULTI CONTROL to select “TUNER FM” or “TUNER

AM” and press SET.

6. Select the preset channel for the station to be recorded.

Press MULTI CONTROL 4 P. DOWN or ¢P. UP to select.

7. Press SET.

The REC indicator stops flashing and remains lit. The on-time, off-time, and Recording band (“TUNER FM” or “TUNER AM”) appear on the display.

Turn the power off if you made the timer settings with the power turned on.

A few seconds before the on-time for the recording, the Unit automatically turns on the power. When the on-time comes, recording starts using the selected source. A few seconds before the off-time, “OFF” flashes on the display. When the off-time comes, the power is automatically turned off.

Before the timer starts

Check that tape direction is correct. This is important especially when Reverse Mode is off.

Set Reverse Mode on if you want to record on both sides of the tape.

The volume level is automatically set to 0 when Recording Timer starts.

It is very easy, and can be very disappointing, to forget to put in a tape, or to accidentally leave a tape in Deck B you don’t want recorded over. Although this happens to almost everyone at one time or another, we hope it won’t happen to you!

To change the Recording Timer setting

Repeat the setting procedure from the beginning.

36

Page 39 Page 41
Image 40
Page 39 Page 41
Contents CA-D702T If in Doubt Consult a Competent Electrician Class Laser Product Precaución el aparato debe estar bien ventilado Precaução Ventilação adequadaFeatures Installation of the UnitPower cord How This Manual Is OrganizedTable of Contents Accessories Setting the Voltage Selector SwitchHow to Put Batteries in the Remote Control Using the Remote ControlConnecting the FM Antenna Connecting the AM AntennaUsing the Supplied Wire Antenna Using an FM 75-Ohm Antenna Cable not suppliedConnecting the Optional Speakers Connecting the SpeakersRight Speaker Connecting Auxiliary Equipment On the Remote ControlVCR or other equipment On the UnitCommon Operations Demo ModeDisplay Setting the Clock Turning the Power On and OffAdjusting the Volume Turning the System OnBalance Adjustment Reinforcing the Bass SoundFor private listening Press Shift Press Balance L 10 or R +10Customizing a Sound Mode Sound ModesWhen a Rear Speaker is Connected Adjusting the Rear Speaker LevelUse Multi Control to adjust to any Sound Mode desired FrontTurn down the volume level to Press AUX Listening to Auxiliary EquipmentDolby Surround Accessing the Dolby Surround Functions3CH Logic Center Speaker Mode Delay Time ModeAdjusting the level of the Center Speaker Adjusting the level of the Rear Speakers for PRO Logic onlyGetting Ready to Use Dolby Pro Logic Setting-up Dolby Pro LogicSpeaker Arrangements for Dolby Pro Logic Using Dolby Surround Setting-up Dolby 3ch LogicGetting Ready to Use Dolby 3 Channel Logic Speaker Arrangements for Dolby 3 Channel LogicTuning in a Station Using the TunerSetting the AM Tuner Interval Spacing Switching between Frequency Bands Presetting StationsThree Ways to Select a Station Changing the FM Reception Mode Using the CD Player Entering CD Operation Mode with the Remote ControlDisc indicator CD indicatorLoading CDs Basics of Using the CD Player Continuous PlayPlaying a CD Locating a Track with the Remote Control Directly Selecting a TrackFast Forward / Reverse Changing Discs While PlayingOn the Remote Control Press PROGRAM/RANDOM on the Unit Programing the Playing OrderTracks On the Unit Press PROGRAM/RANDOMRandom Play Checking the ProgramChanging the Program Press the number keys 1 to 10 and +10 to select the tracksRepeating a Track or the Discs Tray Lock FunctionLocking the Trays Unlocking the TraysEntering the Tape Operation Mode with the Remote Control Using the Cassette DeckTape ª £ Regular Play Music ScanFast Left and Fast Right Finding the Beginning of the Current SelectionReverse Mode Reverse Mode on Reverse Mode OFFRecording Things to Know before You Start RecordingStandard Recording Check the recording direction for the tapePress Tape Control then press To pause at any time during the recording processAuto Edit Recording CD Direct RecordingRecording AM Station to Tape How to Use Dubbing Tape to Tape Recording DubbingPress Dubbing To stop dubbing, press 7STOPUsing the Timer Setting the Daily Timer Press TIMER/CLOCK againSet the time you want the Unit to turn on Set the time you want the Unit to turn offTurning the Daily Timer On and Off Setting the Volume LevelTo change the Daily Timer setting To use a Cassette Deck as the sourceSetting the Recording Timer Setting the Sleep Timer Turning the Recording Timer On and OffTo change the Sleep Timer setting To cancel the Sleep Timer settingTimer Priority Example Setting OperationRecording Timer Sleep TimerUsing the Microphone Karaoke Sing AlongSound Display Singing Along with KaraokeDigital Echo Press FM MODE/ECHO on the Remote ControlRecording Your Singing Microphone Mixing Playing the Microphone Sound through the SpeakersRecording Microphone Mixing Recording from the MicrophoneCare and Maintenance Compact Discs Cassette TapesMoisture Condensation General NotesTroubleshooting SymptomPossible Cause ActionSpecifications Important for mains AC line
Top Page Image Contents