JVC RX-5030VBK manual Selecting the Digital Input Terminals, Crossover frequency-CROSSOVER

7Speaker distance—DISTANCE UNIT,

FRNT (Front) DISTANCE, CNTR (Center) DISTANCE, SURR (Surround) DISTANCE

Select the unit to measure the distance between your listening position and speakers—“METER” or “FEET.”

After selecting the measuring unit, select the appropriate speaker distance for each speaker within the range of “0.3m” (“1FT”) to “9.0m” (“30FT”) by 0.3 m (1 foot) step.

Example:In this case, set “FRNT DISTANCE” to “3.0m” (“10FT”), “CNTR DISTANCE” to “2.7m” (“9FT”), and “SURR DISTANCE” to “2.4m” (“8FT”).

L C R

3.0 m

(10 feet)

2.7 m

(9 feet)

2.4 m

(8 feet)

2.1 m

(7 feet)

LSRS

•“METER” for the unit and “3.0m” (“10FT”) for all speakers are the initial settings.

Note:

If you have selected “NONE” for the center and surround speakers setting, you cannot set the speaker distance for the center and surround speakers.

7Crossover frequency—CROSSOVER

Small speakers cannot reproduce the bass sounds efficiently. If you use a small speaker in any position, this receiver automatically reallocates the bass sound elements assigned to the small speaker to other large speakers.

To use this function properly, set the crossover frequency according to the table below:

Crossover frequency	Size of cone speaker unit built in the
	small speaker
80HZ	about 12 cm
100HZ	about 10 cm (initial setting)
120HZ	about 8 cm
150HZ	about 6 cm
200HZ	less than 5 cm

•If you have selected “LARGE” for all speakers, this function will not take effect (“CROSS OFF” appears).

7Low Frequency Effect attenuator—LFE ATTENUATE

If the bass sound is distorted while playing back software encoded with Dolby Digital or DTS Digital Surround, select “–10dB” to activate the Low Frequency Effect attenuator.

•This function takes effect only when the LFE signals come in.

0dB Normally select this (initial setting).

–10dBSelect this when the bass sound is distorted.

7Dynamic range compression—D_COMPRESSION

You can compress the dynamic range (difference between maximum sound and minimum sound) of the reproduced sound. This is useful when using surround sound at night.

•This function takes effect only when playing back a source using Dolby Digital.

MID Select this when you want to reduce the dynamic range a little (initial setting).

MAX Select this when you want to apply the compression effect fully. (Useful at night.)

OFF Select this when you want to enjoy surround sound with its full dynamic range. (No effect applied.)

Selecting the Digital Input Terminals—

DIGITAL IN

When you use the digital input terminals, register which components are connected to which terminals (DIGITAL 1/2) so that the correct source name will appear when you select the digital source.

Select the appropriate option from the following:

1 DVD 2 CD	O 1 DVD	2 TV O 1 DVD 2 CDR O
1 CD 2 DVD	O 1 CD 2 TV		O 1 CD 2 CDR	O
1 TV 2 DVD	O 1 TV 2 CD		O 1 TV 2 CDR	O
1 CDR 2 DVD O 1 CDR		2 CD O 1 CDR 2 TV		O
(back to the beginning)

Note:

When shipped from the factory, the DIGITAL IN terminals have been set for use with the following components:

•DIGITAL 1 (coaxial): For DVD player

•DIGITAL 2 (optical): For CD player

14