Creating Realistic Sound Fields
You can use the following Surround and DSP modes to reproduce a realistic sound field:
Surround modes
7Dolby
•Dolby Pro Logic II
•Dolby Digital
7DTS Digital Surround
DSP modes
7DAP modes
7All Channel Stereo
Surround modes
7Dolby
Dolby Pro Logic II*
Dolby Pro Logic II has a
Dolby Pro Logic II enables reproduction of spacious sound from original sound without adding any new sounds and tonal colorations.
Dolby Pro Logic II has two
Pro Logic II Movie (PLII
Pro Logic II Music (PLII
•When Dolby Pro Logic II is activated, the PRO LOGIC II indicator lights up on the display.
Dolby Digital*
Used to reproduce
•To use software encoded with Dolby Digital, connect the source component to the digital terminal on the rear of this receiver. (See page 9.)
Dolby Digital 5.1 channel encoding method
Since each channel is completely independent from the other channel signals to avoid interference, you can obtain much better sound quality with many stereo and surround effects.
•When Dolby Digital signal comes in, the DIGITAL indicator lights up on the display.
Note:
Dolby Digital software can roughly be grouped into two categories
7DTS Digital Surround**
Used to reproduce
•To use software encoded with DTS Digital Surround, connect the source component to the digital terminal on the rear of this receiver. (See page 9.)
DTS Digital Surround is another discrete
•When DTS signal comes in, the indicator lights up on the display.
Typical multi-channel (5.1 channel) reproduction
Center speaker
Left front | Right front |
speaker | Subwoofer speaker |
Left | Right |
surround | surround |
speaker | speaker |
* Manufactured under license from Dolby Laboratories. “Dolby”, | ** “DTS” and “DTS Digital Surround” are registered trademarks of |
“Pro Logic”, and the | Digital Theater Systems, Inc. |
Laboratories. |
|
22