JVC RX-5030VBK Basic Settings, Selecting the Analog or Digital Input Mode, Press Input Digital

Remote

NOT

Basic Settings

Front panel		Remote control
	INPUT DIGITAL	TA/NEWS/INFO

RX–5032VAUDIO/VIDEO CONTROL RECEIVER

DISPLAY MODE

Source selection

buttons

ANALOG/DIGITAL

Source selection	INPUT ANALOG
buttons

Selecting the Analog or Digital Input

Mode

When you have connected digital source components using both the analog connection (see pages 7 and 8) and the digital connection (see page 9) methods, you need to select the input mode correctly.

1Press one of the source selection buttons— DVD, TV SOUND, CD, or TAPE/CDR*—for which you want to change the input mode.

Note:

*Among the sources listed above, you can select the digital input only for the sources for which you have selected the digital input terminals. (See “Selecting the Digital Input Terminals—DIGITAL IN” on page 14.)

2Select digital input mode.

On the front panel

Press INPUT DIGITAL.

“DIGITAL AUTO” appears on the display. The DIGITAL AUTO indicator also lights up.

If the following symptoms occur while playing Dolby Digital or DTS encoded software with “DIGITAL AUTO” selected, change the digital input mode.

•Sound does not come out at the beginning of playback.

•Noise comes out while searching or skipping chapters or tracks.

Press INPUT DIGITAL on the front panel repeatedly to select “DOLBY DIGITAL” or “DTS SURROUND.”

•Each time you press the button, the digital input mode changes as follows:

DIGITAL AUTO DOLBY DIGITAL

DTS SURROUND

•To play back software encoded with Dolby Digital, select “DOLBY DIGITAL.”

•To play back software encoded with DTS Digital Surround, select “DTS SURROUND.”

Note:

When you turn off the power or select another source, “DOLBY DIGITAL” or “DTS SURROUND” is canceled and the digital input mode is automatically reset to “DIGITAL AUTO.”

To change the input mode back to analog input, press

INPUT ANALOG.

“ANALOG” appears on the display for a while. The ANALOG indicator lights up.

The ANALOG indicator and digital signal format indicators on the display indicate what type of signal comes into the receiver.

From the remote control

Press ANALOG/DIGITAL.

•Each time you press the button, the input mode alternates between the analog input (“ANALOG”) and the digital input (“DIGITAL AUTO”).

DIGITAL AUTO Select this for the digital input mode. The receiver automatically detects the incoming signal format.

ANALOG Select this for the analog input mode (initial setting).

ANALOG Lights when the analog input is selected.

LINEAR PCM Lights when Linear PCM signals come in.

DIGITAL • Lights when Dolby Digital signals come in.

•Flashes when “DOLBY DIGITAL” is selected for software not encoded with Dolby Digital signals.

• Lights when DTS signals come in.

•Flashes when “DTS SURROUND” is selected for software not encoded with DTS signals.

Note:

When “DIGITAL AUTO” cannot recognize the incoming signals, no digital signal format indicators light up on the display.

15