“ASSEMBLY INSTRUCTIONS”
USE HARDWARE KIT C
Please be sure that Bolt (157) would screw through the Shaft
Sleeve (106) inside the
rear end of the Right
Pedal Support Arm
Assembly (14) during
assembly
STEP 11 – Pedal Support Arm Assembly
a. NOTE: Two Washers (6x19x2.0t)(122) and two Bolts, Hex Head (M8xp1.25x16mm)(146) are
b. Remove two Washers (6x19x2.0t)(122) and two Bolts, Hex Head (M8xp1.25x16mm)(146) from the
Rotation Stand (17).
c. Slide the front side of the Right Pedal Support Arm Assembly (14) onto the Rotation Stand (17) and secure with two Washers (6x19x2.0t)(122) and two Bolts, Hex Head (M8xp1.25x16mm)(146)
d.Attach the rear side of the Right Pedal Support Arm Assembly (14) to the Right Pivoting Arm (13) and secure with one Bolt, Button Head (M8xp1.25x90mm)(157), one Shaft Sleeve (106) and one Nylock Nut (M8xp1.25)(171). NOTE: Be certain that Bolt (157) properly fits through the Shaft Sleeve (106) inside the rear end of the Right Pedal Support Arm Assembly (14) during assembly.
e.Repeat the above procedure for the left side pedal arm assembly.
**Make sure the above parts are tightened before moving on to the next page**
12