Rear Stabilizer Assembly, Leveler Assembly

“ASSEMBLY INSTRUCTIONS”

USE HARDWARE KIT A

STEP 3 – Rear Stabilizer Assembly

a.Attach the Rear Stabilizer (8) to the Rear Support Frame Assembly (2).

“Helpful Hint: Only hand tighten the bolts and fasteners in each step. Wait until the step is completed before fully tightening the bolts and fasteners”

b.Attach two Carriage Bolts (M8xp1.25x90mm)(164) that secure the Rear Stabilizer (8) to the Rear Support Frame

Assembly (2).

STEP 4 – Leveler Assembly

Thread the Leveler (38) tightly into the Rear Support Frame Assembly (2). **To properly adjust Leveler (38), please review page 14 of the manual**.

STEP 5 – Rear Support Frame Assembly

a.Connect the Pulse Sensor Wire 3 (182) to the Pulse Sensor Wire 2 (181). Be careful not to pinch the wires.

NOTE: After connecting the wires, slightly and gently pull two sides of wires to test the that the connectors are properly locket together.

NOTE: Four Nylock Nut (M8xp1.25)(171) will be pre-attached on the front of the Rear

Support Frame Assembly (2).

b. Remove four Nylock Nut (M8xp1.25)(171) from the front of the Rear Support Frame Assembly (2)

c. Attach the Rear Support Frame Assembly (2) to the Main Frame (1) and reattach the four Nylock Nut

(M8xp1.25)(171). Be careful not to pinch the wires. Fully tighten nuts now.

d. Attach the Connection Cover (27) to the Main Frame (1) using a Screw, Round Head (M5xp0.8x40mm) (139).

**Make sure the above parts are tightened before moving on to the next page** 8