Smooth Fitness V2300 owner manual Console Trouble Shooting Guide, Problem Possible Cause Solution

“CONSOLE TROUBLE SHOOTING GUIDE“

PROBLEM	POSSIBLE CAUSE	SOLUTION
		1. Motor Malfunction	Replace Motor
		2. Magnetic System	Replace Magnetic System/Flywheel
E1	No Motor signal	Malfunction or got stuck
		3. Connection Wires are not	Check whether the wires are well-connected or replace the
		well-connected or broken	broke wires with the new wires
		4. Console Malfunction	Replace Console
		1. Disconnect the Adaptor or	Batteries. Reconnect the Adaptor or Batteries to REBOOT
E2	The Computer cannot	the system. Wait two minutes then verify that the system works correctly
	make contact with the	2. If IC Chips is not well-assembled. Remove and reinsert the IC Chip
	IC Chip	3. If the above solutions couldn’t solve the problem, replace the IC chip with a New IC
		Chip
	The Computer is
	NOT receiving a	Verify that the Hand Pulse Sensor Wire Plugs are connected FIRMLY and correctly
	Pulse Signal
No Hand		The Hand Pulse Sensors will NOT operate correctly if your skin is extremely dry.
		Moisten your hands with a little water and try again.
Pulse Signal
		Grasp the Hand Pulse Sensors firmly and avoid moving your hands while exercising.
or incorrect	The Computer is
Hand Pulse	receiving a faint or	The computer will need a few seconds to detect and display your correct pulse rate. If
Signal	intermittent Pulse	this does not work, try relaxing your grip on the Hand Pulse Sensors
	Signal	Clean the Hand Pulse Sensors to ensure a good contact between your body and the
		Pulse Sensors
		The problem still exists, replace the Hand Pulse Sensors.
	The Adaptor is not
The LCD	plugged in (item	Check that the Adaptor is correctly connected to an electrical outlet and plugged into
Screen does	power supply from	the socket on the machine correctly
not display	Adaptor)
anything	The Computer is	Replace the Computer
	faulty
	The Computer isn’t	Verify the gap between Speed Sensor and the Magnet is 5mm or less
	receiving a signal
		Verify that all the Wire Plugs are connected FIRMLY, correctly and are not damaged
The Speed	from the Speed
Display Show	Sensor?	Verify that the Sensor Magnet is installed correctly
“0”	The Sensor is faulty	Replace the Speed Sensor
	The Computer is	Replace the Computer
	faulty

20