Smooth Fitness V2300 owner manual HOW to Change the Wlliptical Bike Motion

Page 16

“OPERATION INSTRUCTIONS”

HOW TO CHANGE THE WLLIPTICAL BIKE MOTION

STEP MODE:

The item can be used in the ELLIPTICAL mode or the STEP mode.

Refer to the following process to set up the ELLIPTICAL mode or the STEP mode.

a.Before exchanging the ELLIPTICAL mode with the STEP mode, make sure the SIDE YOU ARE ADJUSTING IS IN the lowest position as the figure shows below

b.Remove the Locking Knob (68) from the Right Pivoting Arm (13)

c.Attach the Right Pedal Linkage (19) to the Rear Stabilizer (8) and fully tighten the Locking Knob (68)

d.Repeat the above process on the left side

CAUTION: Make sure both Locking Knobs (68) are tightened before exercising

ELLIPTICAL MODE:

16

Image 16

Contents V2300 Safety Instruction Assembly Parts Hardware Identification Chart Hardware KIT CHardware KIT B Before YOU Begin Front Stabilizer Assembly Assembly InstructionsHandlebar Assembly Leveler Assembly Rear Stabilizer AssemblyRear Support Frame Assembly Seat Support Slider Assembly Seat Carriage AssemblyShort Extension Pulse Wire & Rail Decoration Assembly Adjusting Handle AssemblyAssembly Instructions Seat and Seat Handlebar AssemblyPedal Support Arm Assembly USE Hardware KIT CPedal Linkage and Pedal Assembly AC AdaptorHOW to Adjust the Adjusting Endcaps of the Rear Stabilizer Operation InstructionsHOW to Adjust the Seat HOW to Change the Wlliptical Bike Motion Page Power on Console InstructionsConsole Functions Console Trouble Shooting Guide Problem Possible Cause SolutionScreen Partially Conditioning Guidelines Exercise IntensityWARM-UP and COOL-DOWN Suggested Stretching ExercisesProduct Parts Drawing a Product Parts Drawing B Part List QTYPart List Part List Limited Home USE Warranty Smooth Fitness Bicycle Warranty