Huffy M0073 manual Handlebar and Stem Instal, One Bolt Stem various models

Handlebar and Stem Instal

WARNING: To prevent steering system damage and possible loss of control, the “MIN-IN” (minimum insertion) mark (A) on the stem must be below the top of the Locknut (B).

Assembly

NOTE: Remove plastic Cap (E) from the end of the Stem (13).

1.Insert the Stem (13) into the fork (fig 07).

2.Point the Stem (13) towards the front of the bike.

3.Tighten the Stem Bolt (C) just enough to hold it in position.

4.If necessary, loosen the Handlebar Clamp Nut (D) and rotate Handlebar (12) into a comfortable riding position

(fig 08).

5.Tighten Handlebar Clamp Nut (D) just enough to hold it in position (fig 08).

6.Align the stem (13) with the front tire and tighten the stem bolt (C) securely (fig 07).

WARNING: Do not over tighten the stem bolt. Over tightening the stem bolt can damage the steering system and cause loss of control.

One Bolt Stem (various models):

•If necessary, re-adjust Handlebar (12) (fig 08).

•Tighten Clamp Nut (D).

NOTE: Do not over tighten. Torque to 17 ft-lbs.

WARNING: If the handlebar clamp in not tight enough, the handlebar can slip in the stem. This can cause damage to the handlebar or stem, and can cause loss of control.

C

13

A

E

B B A

fig 07

12

D

fig 08

14