Precor S3.15 manual Install Ab Cable and Floating Pulleys

S3.15 Assembly and Maintenance Guide

7.Install Ab Cable and Floating Pulleys

A.Start at the center pulley on the Main Upright. Feed the threaded end of Ab Cable 130196 through the opening and over one 3½-inch pulley. Attach the pulley to the Main Upright using

one 4-inch hex head bolt two flat washers

one locknut

B.Disassemble the 3½-inch pulley located inside the Single Floating Pulley. Feed the cable around the pulley and reattach the pulley using

one 1¹⁄₂-inch zinc hex head bolt two zinc washers

one thin zinc locknut Wrench tighten.

C.Disassemble the lower portion of the Double Floating Pulley. Feed the cable around the lower pulley and reattach it using

one 2-inch zinc hex head bolt two zinc flat washers

one zinc locknut

D.Attach the threaded end of the cable to a Single Floating Pulley. Continue turning the screw three to four full turns to secure it inside the floating pulley housing.

F.Remove any twists in the cables, and then wrench tighten all pulley fasteners.

		1	- 4" bolt	A
		2	- washers
		1	- locknut
							1	- 2" zinc bolt
							C 2	- zinc washers
							1	- zinc locknut
Single Floating
Pulley Assembly
1	- 1½" zinc bolt
2	- zinc washers
1	- zinc locknut
					B	D
	1		2	3		4	5	6

Step 7. Install Ab Cable and Floating Pulleys

page 19