S3.15 Assembly and Maintenance Guide
Appendix – Shroud Assembly
Two acrylic Shrouds can be attached to the Main Frame. Complete the assembly steps for one side of the unit before moving the other.
The frosted side of the Shroud faces the Weight Stack. Install the Shrouds so the cutouts allow access to the Weight Stack Pin.
Important: Handle each Shroud with care. The shrouds require special handling as they are easily scratched. For proper care and maintenance, refer to Adjustments and Maintenance in this guide.
A.Attach a Shroud to each side of the Main Frame using
6 -
6 - tapered spacers
Note: Start with top fasteners and work toward the base. Ask your assistant to hold the Shroud in place while you insert the top spacers and fasteners. Alternately finger tighten all six fasteners while adjusting the alignment.
B.Wrench tighten using a 5mm hex key.
CAUTION: Do not over tighten. You can crack or warp the Shroud if too much pressure is applied to the fasteners.
6 - 1³⁄₄" buttonhead screws |
|
|
|
|
|
A 6- tapered spacers |
|
|
|
|
|
Shroud (frosted side |
|
|
|
|
|
faces weight stack) |
|
|
|
|
|
|
|
|
|
| Shroud (frosted side |
|
|
|
|
| faces weight stack) |
Cutout in |
|
|
|
|
|
Shroud |
|
|
|
|
|
1 | 2 | 3 | 4 | 5 | 6 |
Appendix – Shroud Assembly
page 31