Precor S3.25 manual Adjustments, Stretch the Cable

Page 16

S3.25 Leg Press Option Assembly Instructions

4 Adjustments

After the Leg Press Option is assembled, you should check the Cables for proper tension. These are some obvious signs that cable problems exist:

Excess slack exists in the Cable.

The Top Cap Weight does not rest squarely on the Weight Stack.

The Cable rubs the inside edges of the pulleys.

CAUTION: Take the time to perform the following steps. If the Cables do not have

the proper tension, you could damage the machine and void the Precor Limited Warranty.

Note: To adjust the Selector Stem, refer to the S3.25 Assembly and Maintenance Guide.

1. Stretch the Cable

A.Sometimes a new cable must be stretched so that the Top Cap Weight rests on the Weight Stack. To lengthen the Cable, insert the Weight Pin at a comfortable weight level.

B.Push up on the Chest Press Arms, and then slowly lower them.

C.Make sure the Top Cap Weight rests squarely on the Weight Stack. If it does, no more adjustments are needed, and the Leg Press Option is ready to use. If the Top Cap Weight does not rest on the Top

 

 

 

A

 

 

 

 

 

Top Cap Weight

 

 

 

 

Top Weight

 

 

 

 

 

Weight Pin

 

 

 

 

 

B

C

 

 

 

 

 

 

 

 

Chest Press Arms

Top Cap

 

 

 

 

 

Weight

 

1

2

3

4

5

6

Adjustments

page 16

Image 16
Contents S3.25 Safety Instructions Important Safety InstructionsTable of Contents 1Before You Begin Before You BeginPreparations AssemblyInstructions Assembly InstructionsRemove the Shroud Attach the Cross Brace to the S3.25 Assemble the Frame Locking it in place with the Pop PinAssemble the Frame Assemble the Seat Pads Route the Cable Assemble the Cable and Pulleys Assemble the Cable and Pulleys Replace the Shroud Adjustments Stretch the CableRotate the Cam Washer Adjust the Rubber Bumper on the Leg Press Option Residential Equipment Limited Warranty ConditionsWarranty Registration Card
Related manuals
Manual 22 pages 36.11 Kb Manual 22 pages 61.67 Kb