Huffy M6611043 manual Dimple Hole

5.Bounce top and middle pole assembly (4 and 5) onto bottom pole section (6) using a wood scrap as shown. Bounce until the top and middle pole assembly no longer moves toward the pole identification mark on the bottom pole.

IMPORTANT!

Align dimple of middle pole section (5) into trough of bottom pole section (6) as shown.

1-1/2"

Bottom pole

5" ID

STICKER

Bottom pole

DIMPLE

HOLE

5

CAUTION!

THE IDENTIFICATION STICKER IS LOCATED 5" FROM THE END OF THE POLE. WHEN PROPERLY POUNDED TOGETHER, THE POLE SECTIONS SHOULD HAVE A 3-1/2" MINIMUM OVERLAP, LEAVING 1-1/2"

BETWEEN THE OVERLAPPING POLE AND THE IDENTIFICATION STICKER.

4

RODS SHOWN ARE

FOR VISUAL

REPRESENTATION

OF ALIGNMENT

AND ARE NOT

SUPPLIED WITH

THE HARDWARE

6

WOOD SCRAP

(NOT SUPPLIED)

15 01/07 ID# M6611043