4.Bounce top (4) and middle (5) pole assembly onto bottom pole section (6) using a wood scrap as shown. Bounce until the top and middle pole assembly no longer moves toward the taped reference mark on the bottom pole.
IMPORTANT!:
Holes in top (4) and bottom pole (6) sections MUST align to correctly position elevator system toward playing surface.
NOTE: |
POLE SECTIONS |
SHOULD HAVE A |
OVERLAP. |
WOOD SCRAP
(NOT SUPPLIED)
4
5
6
RODS SHOWN ARE
FOR VISUAL
REPRESENTATION
OF ALIGNMENT
AND ARE NOT
SUPPLIED WITH THE HARDWARE
5.Install bolt (12) through bracket and bottom pole section (6) and secure with nut (10) as shown. Nut should be tightened until flush (even) with locknuts outer edge.
6
12
10
P/N 21463607 03/04 | 14 |