5. Add bottom pole section (4) to assembly as shown and bounce until completely tight.
IMPORTANT!
Holes in top and bottom pole
sections MUST align to correctly
position elevator system.
Continue to check alignment while assembling pole sections. *Row of 3 holes on top pole section must be parallel with adjustment knob.
Once assembled, pole sections can NOT be separated!
POLES MUST OVERLAP 3-1/2” (9 CM) MINIMUM.
NOTE: Discard this carriage bolt immediately after completing this step. DO NOT discard flange nut and washer.
* |
5 |
6 |
6 
4 
WOOD SCRAP 
P/N 211387 | 5/99 | 4 | printed on recycled paper |
|